Skip to contentSkip to conversation

Can the driver of a wlan card for PC be used in embedded sytems?

DISCUSSION Li Weichen 2 participants 5 messages Dec 8, 2005 – Dec 9, 2005

lore
Share & tools
lore

Li Weichen

author
#0 lore raw

Hi all,

Is there anybody can tell me that if I can use the wlan card driver for PC in the embedded system? I guess that there is something related to the interface. Then if I use usb will it work? Or do I need to modify some settings in the source code?

By the way can anybody give me some advice on card selection? Anything related to vendors, chips, drivers, interfaces and so on would be helpful. Better 802.11g cards.

Thank you all in advance and best regards!

Li Weichen
2005-12-8

#1 lore raw

You are a lucky guy!
I just did a similiar work today.
you can buy this wlan card: asus w167g (usb)
and get driver from here:
http://rt2x00.serialmonkey.com/rt2570-cvs-daily.tar.gz (for 2.6 kernel)

untar,
edit Makefile and specify your kernel source directory, make arm
insmod ra2570.ko
then using iwconfig to config your wlan card done

2005/12/8, Li Weichen <[email protected]>:

Quoted 22 lines

Hi all,

Is there anybody can tell me that if I can use the wlan card driver for PC in the embedded system? I guess that there is something related to the interface. Then if I use usb will it work? Or do I need to modify some settings in the source code?

By the way can anybody give me some advice on card selection? Anything related to vendors, chips, drivers, interfaces and so on would be helpful. Better 802.11g cards.

Thank you all in advance and best regards!

Li Weichen
2005-12-8

_______________________________________________
Linux-omap-open-source mailing list
[email protected]
http://linux.omap.com/mailman/listinfo/linux-omap-open-source

author
#2 lore raw

Then do you connected it to the usb1.1 port of omap? Will the interface speed limits the wifi performance?

Thanks again.

_____

From: embedos [mailto:[email protected]]
Sent: Friday, December 09, 2005 12:07 AM
To: Li Weichen
Cc: [email protected]
Subject: Re: Can the driver of a wlan card for PC be used in embedded sytems?

You are a lucky guy!

I just did a similiar work today.

you can buy this wlan card: asus w167g (usb)

and get driver from here:

http://rt2x00.serialmonkey.com/rt2570-cvs-daily.tar.gz (for 2.6 kernel)

untar,

edit Makefile and specify your kernel source directory,

make arm

insmod ra2570.ko

then using iwconfig to config your wlan card

done

2005/12/8, Li Weichen <[email protected]>:

Hi all,

Is there anybody can tell me that if I can use the wlan card driver for PC in the embedded system? I guess that there is something related to the interface. Then if I use usb will it work? Or do I need to modify some settings in the source code?

By the way can anybody give me some advice on card selection? Anything related to vendors, chips, drivers, interfaces and so on would be helpful. Better 802.11g cards.

Thank you all in advance and best regards!

Li Weichen
2005-12-8

_______________________________________________
Linux-omap-open-source mailing list
[email protected]
http://linux.omap.com/mailman/listinfo/linux-omap-open-source

#3 lore raw

unfortunately, yes.
you will need usb 2.0 interface to access the full speed of the 80211g wlan card.

2005/12/9, Li Weichen <[email protected]>:

Quoted 75 lines

Then do you connected it to the usb1.1 port of omap? Will the interface
speed limits the wifi performance?

Thanks again.

------------------------------

*From:* embedos [mailto:[email protected]]
*Sent:* Friday, December 09, 2005 12:07 AM
*To:* Li Weichen
*Cc:* [email protected]
*Subject:* Re: Can the driver of a wlan card for PC be used in embedded sytems?

You are a lucky guy!

I just did a similiar work today.

you can buy this wlan card: asus w167g (usb)

and get driver from here:

http://rt2x00.serialmonkey.com/rt2570-cvs-daily.tar.gz (for 2.6 kernel)

untar,

edit Makefile and specify your kernel source directory,

make arm

insmod ra2570.ko

then using iwconfig to config your wlan card

done

2005/12/8, Li Weichen <[email protected]>:

Hi all,

Is there anybody can tell me that if I can use the wlan card driver for PC in the embedded system? I guess that there is something related to the interface. Then if I use usb will it work? Or do I need to modify some settings in the source code?

By the way can anybody give me some advice on card selection? Anything related to vendors, chips, drivers, interfaces and so on would be helpful.

Better 802.11g cards.

Thank you all in advance and best regards!

Li Weichen
2005-12-8

_______________________________________________
Linux-omap-open-source mailing list
[email protected]
http://linux.omap.com/mailman/listinfo/linux-omap-open-source

author
#4 lore raw

Then you implement the usb 2.0 interface with another chip? What is your choice? The OMAP5912 only supports usb1.1 interface.

_____

From: embedos [mailto:[email protected]]
Sent: Friday, December 09, 2005 8:57 AM
To: Li Weichen
Cc: [email protected]
Subject: Re: Can the driver of a wlan card for PC be used in embedded sytems?

unfortunately, yes.

you will need usb 2.0 interface to access the full speed of the 80211g wlan card.

2005/12/9, Li Weichen <[email protected]>:

Then do you connected it to the usb1.1 port of omap? Will the interface speed limits the wifi performance?

Thanks again.

_____

From: embedos [mailto:[email protected]]
Sent: Friday, December 09, 2005 12:07 AM
To: Li Weichen
Cc: [email protected]
Subject: Re: Can the driver of a wlan card for PC be used in embedded sytems?

You are a lucky guy!

I just did a similiar work today.

you can buy this wlan card: asus w167g (usb)

and get driver from here:

http://rt2x00.serialmonkey.com/rt2570-cvs-daily.tar.gz (for 2.6 kernel)

untar,

edit Makefile and specify your kernel source directory,

make arm

insmod ra2570.ko

then using iwconfig to config your wlan card

done

2005/12/8, Li Weichen < <mailto:[email protected]> [email protected]>:

Hi all,

Is there anybody can tell me that if I can use the wlan card driver for PC in the embedded system? I guess that there is something related to the interface. Then if I use usb will it work? Or do I need to modify some settings in the source code?

By the way can anybody give me some advice on card selection? Anything related to vendors, chips, drivers, interfaces and so on would be helpful. Better 802.11g cards.

Thank you all in advance and best regards!

Li Weichen
2005-12-8

_______________________________________________
Linux-omap-open-source mailing list
[email protected]
http://linux.omap.com/mailman/listinfo/linux-omap-open-source
<http://linux.omap.com/mailman/listinfo/linux-omap-open-source>