udev problem ...
-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1
Hi !
Here is a report bug I posted on [email protected] , we'll make it short , I cannot activate udev at boot , if I do this I get IDE errors on both harddisks and if I can enter an X-session, I cannot open a terminal : I get following error message :
"there was a problem with the child process of this terminal" . If I desactivate udev at boot, eveything is going O.K.
The Debian package maintainer thinks it looks like a kernel bug .... This is why I am posting here hoping for help in this matter.
mahashakti89
PS : Could you CC me your answer, I am not on the list .
THANKS
Package : udev Version : 0.076-3
#dpkg --status udev
Package
Package : udev
Version:0.076-3
Status: install ok installed
Priority: optional
Section: admin
Installed-Size: 960
Maintainer: Marco d'Itri <[email protected]>
Architecture: i386
Version: 0.076-3
Provides: hotplug
Depends: libc6 (>= 2.3.5-1), libselinux1 (>= 1.26), libsepol1 (>= 1.8), initscripts (>= 2.85-16), makedev (>= 2.3.1-77), sed (>= 3.95), lsb-base (>= 3.0-6)
Conflicts: lvm-common (<< 1.5.13), hotplug, module-init-tools (<< 3.2-pre9-1), initramfs-tools (<< 0.39)
Description: /dev/ and hotplug management daemon
udev is a daemon which dynamically creates and removes device nodes from /dev/, handles hotplug events and loads drivers at boot time. It replaces the hotplug package and requires a kernel not older than 2.6.12.
II.Descritpion
If I activate udev at boot through some utility like sysvconfig or sysvconfig I have problem with both IDE Disks
(Maxtor 80 G0 and 250 G0) , I get following error message : Drive Seek Complete Data Request, Satus 0x 58, Drive not Ready
for command , and sometimes I cannot log into an X-session.
If I can log in, I cannot open a terminal - gnome-terminal , konsole, xterm - I get following error message :
There was a problem with the child process of this terminal. It is then impossible to type any command.
If I desactivate udev at boot , everything is O.K , no IDE-errors , no problems with gnme-terminal, konsole or xterm.
III. Informations
KERNEL VERSION :
/home/claude# uname -a
Linux ishwara 2.6.14-ck6 #1 SMP Sun Nov 27 10:05:42 CET 2005 i686 GNU/Linux
LIBC6 VERSION :
:/home/claude# dpkg -s libc6 | grep ^Version Version: 2.3.5-8.1
HARDWARE :
Processor = Pentium IV
Motherboard = ASUS P4P800
Chipset = I865 PE
Harddisk 1 =
hdparm -i /dev/hda
/dev/hda:
Model=Maxtor 6Y080P0, FwRev=YAR41BW0, SerialNo=Y31PPXDE Config={ Fixed }
RawCHS=16383/16/63, TrkSize=0, SectSize=0, ECCbytes=57 BuffType=DualPortCache, BuffSize=7936kB, MaxMultSect=16, MultSect=16 CurCHS=16383/16/63, CurSects=16514064, LBA=yes, LBAsects=160086528 IORDY=on/off, tPIO={min:120,w/IORDY:120}, tDMA={min:120,rec:120} PIO modes: pio0 pio1 pio2 pio3 pio4
DMA modes: mdma0 mdma1 mdma2
UDMA modes: udma0 udma1 udma2 udma3 udma4 *udma5 udma6 AdvancedPM=yes: disabled (255) WriteCache=enabled
Drive conforms to: (null): ATA/ATAPI-1 ATA/ATAPI-2 ATA/ATAPI-3
ATA/ATAPI-4 ATA/ATAPI-5 ATA/ATAPI-6 ATA/ATAPI-7
* signifies the current active mode
Harddisk 2 =
hdparm -i /dev/hdb
/dev/hdb:
Model=Maxtor 6L250R0, FwRev=BAH41G10, SerialNo=L6132M9H Config={ Fixed }
RawCHS=16383/16/63, TrkSize=0, SectSize=0, ECCbytes=57 BuffType=DualPortCache, BuffSize=16384kB, MaxMultSect=16, MultSect=16 CurCHS=16383/16/63, CurSects=16514064, LBA=yes, LBAsects=268435455 IORDY=on/off, tPIO={min:120,w/IORDY:120}, tDMA={min:120,rec:120} PIO modes: pio0 pio1 pio2 pio3 pio4
DMA modes: mdma0 mdma1 mdma2
UDMA modes: udma0 udma1 udma2 udma3 udma4 *udma5 udma6 AdvancedPM=yes: disabled (255) WriteCache=enabled
Drive conforms to: (null): ATA/ATAPI-1 ATA/ATAPI-2 ATA/ATAPI-3
ATA/ATAPI-4 ATA/ATAPI-5 ATA/ATAPI-6 ATA/ATAPI-7
* signifies the current active mode
I didn't touch the basic configuration files of udev except some
personal rules for my modem
and USB-Sticks.
Hope you understand my english.
Thanks
mahashakti89
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.2 (GNU/Linux)
Comment: Using GnuPG with Thunderbird - http://enigmail.mozdev.org
iD8DBQFDmplyPPuyRSaD7LoRAk7DAJ0ddxljwM2pRCLCB1ZZPaeeG23vvgCgiM7c bw2MG2i6kDy2zM0xxV7jbNk=
=1uMy
-----END PGP SIGNATURE-----
Quoted 11 lines · On Sat, Dec 10, 2005 at 10:01:39AM +0100, mahashakti89 wrote:
Hi !
Here is a report bug I posted on [email protected] , we'll make it short , I cannot activate udev at boot , if I do this I get IDE errors on both harddisks and if I can enter an X-session, I cannot open a terminal : I get following error message :
"there was a problem with the child process of this terminal" . If I desactivate udev at boot, eveything is going O.K.
The Debian package maintainer thinks it looks like a kernel bug .... This is why I am posting here hoping for help in this matter.
Can you try the 2.6.15-rc5 kernel release to see if this is better?
thanks,
greg k-h
-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1
Quoted 14 lines · Greg KH
Quoted 10 lines · On Sat, Dec 10, 2005 at 10:01:39AM +0100, mahashakti89 wrote:
Hi !
Here is a report bug I posted on [email protected] , we'll make it short , I cannot activate udev at boot , if I do this I get IDE errors on both harddisks and if I can enter an X-session, I cannot open a terminal : I get following error message :
"there was a problem with the child process of this terminal" . If I desactivate udev at boot, eveything is going O.K.
The Debian package maintainer thinks it looks like a kernel bug .... This is why I am posting here hoping for help in this matter.
Quoted 7 lines
Can you try the 2.6.15-rc5 kernel release to see if this is better?
thanks,
greg k-h
I did it, but it is not better ..... but perhaps due to an upgrade on my debian Sid it seems
that I have not so much IDE errors but this impossibility to open any terminal is already here ...
I tried one Debian pre-packaged kernel and it works , I mean nearly no IDE errors
and no more problems with opening gnome-terminal, so it would mean that here is a problem
in my kernel config ??
Here is an extract of the - so mentioned in the doc - important settings :
# Pseudo filesystems
#CONFIG_PROC_FS=yCONFIG_PROC_KCORE=yCONFIG_SYSFS=yCONFIG_TMPFS=y
# CONFIG_HUGETLBFS is not set
# CONFIG_HUGETLB_PAGE is not setCONFIG_RAMFS=y
# CONFIG_RELAYFS_FS is not set
Where should I look to solve it definetely ??
Thanks for your answer.
mahashakti89
Hope there is no problem if I CC you this message .. -----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.2 (GNU/Linux)
Comment: Using GnuPG with Thunderbird - http://enigmail.mozdev.org
iD8DBQFDmzlpPPuyRSaD7LoRAnguAJ9qktzBbdMdSErbGv+H9Fn33kZrxwCfYZhw ND2wNBura+nQ+e6IZ78M97k=
=UteB
-----END PGP SIGNATURE-----