Skip to contentSkip to conversation

add monitor and qos entries to Kconfig

ipw2200 Daniel Paschka 1 participant 1 message Jan 5, 2006 1 message not in the archive

lore
Share & tools
lore

A message that is not in the archive (sent off-list or not yet received): [email protected]

#1 lore raw
Quoted 23 lines · Andreas Happe

Add the following config entries for the ipw2200 driver to drivers/net/wireless/Kconfig
* IPW2200_MONITOR
enables Monitor mode
* IPW2200_QOS
enables QoS feature - this is under development right now, so it depends upon EXPERIMENTAL

driver compiles and enters monitor mode.

net/wireless/Kconfig renamed from net/wireless/Kconfig.orig +6 -0
@@ -217,6 +217,19 @@ config IPW2200
           say M here and read <file:Documentation/modules.txt>.  The module
           will be called ipw2200.ko.
 
+config IPW2200_MONITOR
+        bool "Enable promiscuous mode"
+        depends on IPW2200
+        ---help---
+	  Enables promiscuous/monitor mode support for the ipw2200 driver.
+	  With this feature compiled into the driver, you can switch to 

net/wireless/Kconfig config IPW2200 · line 235

Quoted 10 lines
net/wireless/Kconfig renamed from net/wireless/Kconfig.orig +7 -0
+	  promiscuous mode via the Wireless Tool's Monitor mode.  While in this
+	  mode, no packets can be sent.
+
+config IPW2200_MONITOR
+        bool "Enable QoS support"
+        depends on IPW2200 && EXPERIMENTAL
+
 config IPW_DEBUG
 	bool "Enable full debugging output in IPW2200 module."
 	depends on IPW2200

I think you made a copy&paste error here. QoS is enabling monitor mode. You probably meant IPW_QOS.