DELL 600/800 - PPC frequency change issues
When unplugging the AC adapter on these machines
following happens in BIOS:
- ACPI processor event fired, frequencies get limited to the lowest one(600 MHz) and BIOS already sets lowest freq.
- when waiting about 10 seconds another ACPI processor event is fired, and all frequencies are available again, highest freq(1700 MHz) is set.
- when plugging in ac adapter before waiting 10 seconds ACPI processor event is happening immediately and all frequencies are available again, highest freq(1700 MHz) is set.
I found these bugs in kernel:
- speedstep centrino driver does not recognise that BIOS changed the frequency behind it's back.
It tells you that 600 MHz are already set, and does not invoke PRE/POST transition validation.
On next frequency settings, the frequency is "out_of_sync" and the validater assumes 600 MHz and the frequency stays there. Not sure, maybe it stayed on 600 because of next bug or both, still the "out_of_sync" is valid and should be handled gracefully:
Patch [1/2]
- userspace governor is using its own cpufreq_policy struct and forgets to set max_frequency there in cpufreq_governor_userspace(CPUFREQ_GOV_LIMITS)
That results in scaling_setspeed staying high in sysfs even the frequency has been lowered on _PPC change.
When _PPC allows all frequencies again, the userspace governor uses it's own policy_struct with the old max value again (now the low one) and the frequency still stays at lowest frequency.
Patch [2/2]
I tested with ondemand and userspace governor on a speedstep-centrino system, both governors had problems with but should work fine with _PPC changes whether the BIOS prechanges the freq or not.
Could someone please review.
Thanks,
Thomas