AMD Alchemy UART: claim memory range
PATCH 1/1 AMD Alchemy UART: claim memory range
Resending since there was no reaction since the initial mail (4/4/2006)...
I've noticed that the 8250/Au1x00 driver (drivers/serial/8250_au1x00.c) doesn't claim UART memory ranges and uses wrong (KSEG1-based) UART addresses instead of the physical ones.
WBR, Sergei
Sighed-off-by Sergei Shtylyov <[email protected]>
drivers/serial/8250.c +6 -0
@@ -1906,6 +1906,9 @@ static int serial8250_request_std_resourint ret =0 ;switch (up->port.iotype) { +case UPIO_AU : + size =0x100000 ; +/* fall thru */ case UPIO_MEM :if (!up->port.mapbase)break ;
@@ -1938,6 +1941,9 @@ static void serial8250_release_std_resouunsigned int size =8 << up->port.regshift;switch (up->port.iotype) { +case UPIO_AU : + size =0x100000 ; +/* fall thru */ case UPIO_MEM :if (!up->port.mapbase)break ;
drivers/serial/8250_au1x00.c +2 -3
@@ -30,13 +30,12 @@ { \ .iobase = _base, \ .membase = (void __iomem *)_base,\ - .mapbase = _base, \ + .mapbase = CPHYSADDR(_base), \ .irq = _irq, \ .uartclk = 0, /* filled */ \ .regshift = 2, \ .iotype = UPIO_AU, \ - .flags = UPF_SKIP_TEST | \ - UPF_IOREMAP, \ + .flags = UPF_SKIP_TEST \ }static struct plat_serial8250_port au1x00_data[] = {