Skip to contentSkip to conversation

SLC90E66: config_drive_for_dma() cleanup

PATCH New Sergei Shtylyov 1 participant 1 message May 11, 2006 libata

lore
Share & tools
lore
#0 lore raw

PATCH 1/1 SLC90E66: config_drive_for_dma() cleanup

Hello.

Clean up config_drive_for_dma() from the useless code as there's no need
for PIO fallback here since this is done by its caller, slc90e66_config_drive_xfer_rate().
Also, while at it, simplify slc90e66_config_drive_xfer_rate() a bit.

MBR, Sergei

drivers/ide/pci/slc90e66.c +5 -8
Index: linus/drivers/ide/pci/slc90e66.c
===================================================================
@@ -2,6 +2,7 @@
  *  linux/drivers/ide/pci/slc90e66.c	Version 0.11	September 11, 2002
  *
  *  Copyright (C) 2000-2002 Andre Hedrick <[email protected]>
+ *  Copyright (C) 2006 MontaVista Software, Inc. <[email protected]>
  *
  * This a look-a-like variation of the ICH0 PIIX4 Ultra-66,
  * but this keeps the ISA-Bridge and slots alive.
@@ -161,10 +162,8 @@ static int slc90e66_config_drive_for_dma
 {
 	u8 speed = ide_dma_speed(drive, slc90e66_ratemask(drive));
 
-	if (!(speed)) {
-		u8 tspeed = ide_get_best_pio_mode(drive, 255, 5, NULL);
-		speed = slc90e66_dma_2_pio(XFER_PIO_0 + tspeed);
-	}
+	if (!speed)
+		return 0;
 
 	(void) slc90e66_tune_chipset(drive, speed);
 	return ide_dma_enable(drive);
@@ -179,10 +178,8 @@ static int slc90e66_config_drive_xfer_ra
 
 	if (id && (id->capability & 1) && drive->autodma) {
 
-		if (ide_use_dma(drive)) {
-			if (slc90e66_config_drive_for_dma(drive))
-				return hwif->ide_dma_on(drive);
-		}
+		if (ide_use_dma(drive) && slc90e66_config_drive_for_dma(drive))
+			return hwif->ide_dma_on(drive);
 
 		goto fast_ata_pio;