Q: how to send ATA cmds to USB drive?
A message that is not in the archive (sent off-list or not yet received): [email protected]
Quoted 12 lines · Herbert Rosmanith
good day,
I have a question concerning sending arbitrary ATA commands to an USB drive.
Currently, I have a particular application which sends special ATA commands to an IDE drive using
IDE_TASKFILE. So far, this works pretty well.But now I also have to support USB harddisks from the same company. The USB harddisk uses the same set of ATA commands as the IDE harddisk, well, at least that's what I suppose.
Quoted 6 lines
How do I send ATA commands to this USB drive? I suppose this would be done via
SG_IO(the drive is recognised by linux as usb-storage, of course), but how exactly does this have to be done? I have already usedSG_IObefore to send some MMC commands to cdvd-drives, but I don't know how to send ATA (such as those from T13) commands with this interface.
Short answer is you likely can't. The USB-to-IDE bridge pretty much entirely hides the fact that it's an IDE drive behind it, from the host's viewpoint it looks pretty much like SCSI. Maybe if you sent SCSI commands to the device it would translate them into the correct ATA commands, depending on what exactly you're doing, but that's entirely dependent on the bridge chip in question and I would guess most of them don't support such fancy operations.
Signature · 3 lines
Robert Hancock Saskatoon, SK, Canada To email, remove "nospam" from [email protected] Home Page: http://www.roberthancock.com/
Quoted 13 lines · Robert Hancock
Quoted 12 lines · Herbert Rosmanith
good day,
I have a question concerning sending arbitrary ATA commands to an USB drive.
Currently, I have a particular application which sends special ATA commands to an IDE drive using
IDE_TASKFILE. So far, this works pretty well.But now I also have to support USB harddisks from the same company. The USB harddisk uses the same set of ATA commands as the IDE harddisk, well, at least that's what I suppose.
Quoted 8 lines
Quoted 6 lines
How do I send ATA commands to this USB drive? I suppose this would be done via
SG_IO(the drive is recognised by linux as usb-storage, of course), but how exactly does this have to be done? I have already usedSG_IObefore to send some MMC commands to cdvd-drives, but I don't know how to send ATA (such as those from T13) commands with this interface.Short answer is you likely can't. The USB-to-IDE bridge pretty much entirely hides the fact that it's an IDE drive behind it, from the host's viewpoint it looks pretty much like SCSI. Maybe if you sent SCSI commands to the device it would translate them into the correct ATA commands, depending on what exactly you're doing, but that's entirely dependent on the bridge chip in question and I would guess most of them don't support such fancy operations.
AFAIK most are not really pure bridges, but really microcontrollers running a tiny firmware. So there is a non-zero chance of there being an 'ata passthrough' SCSI command.
I would try to the official ATA_12 and ATA_16 SCSI commands first, to see if they do something useful.
Jeff