USB devices fail unnecessarily on unpowered hubs
A message that is not in the archive (sent off-list or not yet received): [email protected]
A message that is not in the archive (sent off-list or not yet received): [email protected]
Quoted 4 lines · Alan Stern
Quoted 2 lines
(Goes away and pats all his 240V plugpacks which are happily working off 110V).
They probably will. The question is, how far out-of-spec should the kernel allow by default? 200% is likely to be too far (your plugpacks notwithstanding).
I would say by default the kernel should not allow any out-of-spec power condition. Some devices might decide to go into over-current mode if a device draws too much power, taking down other devices on the USB bus. This sort of behavior should only be enabled if the user explicitly chooses to live dangerously.
Especially given the fact that Windows enforces the USB power supply limits strictly, and that's where all the hardware is best tested..
Signature · 3 lines
Robert Hancock Saskatoon, SK, Canada To email, remove "nospam" from [email protected] Home Page: http://www.roberthancock.com/