udev not called on USB disconnect
Hello,
I'm trying to do automount/umount for my Canon camera using udev. The camera does not support mass storage so I'm using gphotofs+fuse to access it. I created canon.rules file in /etc/udev/rules.d which contains:
BUS=="usb", SYSFS{idVendor}=="04a9", SYSFS{idProduct}=="306e", ACTION=="add", RUN+="/usr/bin/gphotofs /mnt/camera -o allow_other" BUS=="usb", SYSFS{idVendor}=="04a9", SYSFS{idProduct}=="306e", ACTION=="remove", RUN+="/sbin/umount -f /mnt/camera"
(the file contains only two lines).
When I plug in the camera, the first rule is executed and camera mounted properly. However, disconnecting it does not do anything, the second rule is never executed. I also tried rule as simple as:
BUS=="usb", RUN+="/bin/touch /123"
If I understand udev correctly, that should create /123 file on each USB event. It works when connecting the camera but does not do anything on disconnect.
USB connect/disconnect is properly detected by kernel (2.6.16):
usb 1-2: new full speed USB device using uhci_hcd and address 22 usb 1-2: configuration #1 chosen from 1 choice
usb 1-2: USB disconnect, address 22
Is this a bug or a feature?
Signature · 1 line
Ondrej Zary
Quoted 10 lines · Ondrej Zary
Hello,
I'm trying to do automount/umount for my Canon camera using udev. The camera does not support mass storage so I'm using gphotofs+fuse to access it.
I created canon.rules file in/etc/udev/rules.dwhich contains:BUS=="usb", SYSFS{idVendor}=="04a9", SYSFS{idProduct}=="306e", ACTION=="add", RUN+="/usr/bin/gphotofs
/mnt/camera-oallow_other" BUS=="usb", SYSFS{idVendor}=="04a9", SYSFS{idProduct}=="306e", ACTION=="remove", RUN+="/sbin/umount -f/mnt/camera"
You can't read sysfs values when a device is removed, because those sysfs files are not present anymore. Try testing the environment variables instead.
Quoted 10 lines
(the file contains only two lines).
When I plug in the camera, the first rule is executed and camera mounted properly. However, disconnecting it does not do anything, the second rule is never executed. I also tried rule as simple as:BUS=="usb", RUN+="/bin/touch /123"
If I understand udev correctly, that should create /123 file on each USB event. It works when connecting the camera but does not do anything on disconnect.
Are you sure that no other rule ahead of this one stopped this rule from ever being read?
Also, udev questions belong on the linux-hotplug-devel mailing list...
thanks,
greg k-h