Skip to contentSkip to conversation

CPUFreq ability to overclock

DISCUSSION Eduard-Gabriel Munteanu 2 participants 2 messages Jun 22, 2006

lore
Share & tools
lore
#0 lore raw

*This message was transferred with a trial version of CommuniGate(r) Pro*
I'm thinking to implement a way to have CPUFreq's maximum FSB increased to allow overclocking. Having that done, it should make sense to have a governor (userspace maybe, with a 3rd-party tool) thermal-throttle the CPU. There is one slight problem: can we control Vcore from within the kernel, on-the-fly, without rebooting? I've seen a comment about scaling voltages in cpufreq.c, but it seems there is no actual support for that.

My idea is to make cpufreq_policy.max (same for cpufreq_cpuinfo's member) a soft limit (to prevent unwanted overclocking from usual governors) and have another member hold the hard limit. Chipset drivers should calculate the hard limit based on installed processor or boot-time FSB.

I'm looking forward to comments and suggestions.

#1 lore raw
Quoted 2 lines · Eduard-Gabriel Munteanu

I've seen a comment about scaling voltages in cpufreq.c, but it seems
there is no actual support for that.

Cpufreq operates in terms of "operating points" which are voltage/frequency pairs, rather than just voltages. All the CPU drivers which support it have a voltage corresponding to each frequency to make an operating point.

J