Skip to contentSkip to conversation

kernel 2.6 config for module load

DISCUSSION Jim 2 participants 2 messages Jul 2, 2006

lore
Share & tools
lore

Jim

author
#0 lore raw

Hello,

I have a device driver which can be configurated in kernel 2.4 to be a loadable module. But, in kernel 2.6, I made it as tristate in Kconfig. On make menuconfig list, I can only select it to [*]NewModule for kernel built-in, I cannot select it to [M]NewModule for loadable module (neither did I press key M or Space key produce [M]). Is it wrong to specify tristate in Kconfig to make a loadable module in kernel 2.6? Or what was I missing in kernel 2.6 config?

Thank you.

Jim

#1 lore raw
Quoted 9 lines · On Sun, 02 Jul 2006 21:53:38 +1000 Jim wrote:

Hello,

I have a device driver which can be configurated in kernel 2.4 to be a loadable module. But, in kernel 2.6, I made it as tristate in Kconfig. On make menuconfig list, I can only select it to [*]NewModule for kernel built-in, I cannot select it to [M]NewModule for loadable module (neither did I press key M or Space key produce [M]). Is it wrong to specify tristate in Kconfig to make a loadable module in kernel 2.6? Or what was I missing in kernel 2.6 config?

Tristate is OK. Of course, you will also need
CONFIG_MODULES=y
to enable module support. Is that enabled?

There are a few hundred examples of tristate loadable modules in Kconfig files that you could look at.

---
~Randy