disable debug output for pp_tpc
PATCH 1/1 disable debug output for pp_tpc
Hi Christophe,
this patch removes the debug output for pp_tpc and also decreases the priority ratings so that the passive path will have a priority of 0.
Please apply,
Hannes
Signature · 4 lines
Dr. Hannes Reinecke [email protected] SuSE Linux Products GmbH S390 & zSeries Maxfeldstraße 5 +49 911 74053 688 90409 Nürnberg http://www.suse.de
path_priority/pp_tpc/pp_tpc.c +3 -9
@@ -62,18 +62,13 @@ int sgi_tpc_prio(const char *dev) goto out; } -if (/* Auto-volume Transfer Enabled */ - (sense_buffer[8 ] &0x80 ) !=0x80 ) { -fprintf (stderr,"Auto-volume Transfer not enabled" ); - } -if (/* Current Volume Path Bit */ ( sense_buffer[8 ] &0x01 ) ==0x01 ) {/* * This volume was owned by the controller receiving * the inquiry command. */ - ret |=0x02 ; + ret |=0x01 ; }/* Volume Preferred Path Priority */
@@ -83,7 +78,7 @@ int sgi_tpc_prio(const char *dev)* Access to this volume is most preferred through * this path and other paths with this value. */ - ret |=0x04 ; + ret |=0x02 ;break ;case 0x02 :/*
@@ -91,8 +86,7 @@ int sgi_tpc_prio(const char *dev)* as a secondary path. Typically this path would be used * for fail-over situations. */ - ret |=0x01 ; -break ; +/* Fallthrough */ default :/* Reserved values */ break ;