ethernet configuration scripts of SuSE 10.0 broken
When booting kernel 2.6.18-rc7-mm1 on my SuSE Linux 10.0 system, setup of the Ethernet interface fails. The startup screen displays:
Waiting for mandatory devices: eth-id-00:b0:d0:ed:50:2a __NSC__ 14 13 11 10 9 8 6 5 4 2 1 0
eth-id-00:b0:d0:ed:50:2a No interface found
failed
and there is no network connectivity. Running the command:
# rcnetwork start
displays:
eth0 No configuration found for eth0
and doesn't bring up the interface either. Explicitly specifying the configuration with:
# ifup eth-id-00:b0:d0:ed:50:2a eth0
however brings up the interface successfully. So it seems that it's just SuSE's convoluted tangle of network startup scripts which is somehow confused by some subtle change in how Ethernet interfaces present themselves to userspace in this mm release.
Neither kernel 2.6.18 (release) nor 2.6.18-rc6-mm2 exhibit that problem.
Hardware: Dell OptiPlex GX110, Intel Pentium III, 933 MHz, 512 MB RAM, i810 chipset, Ethernet controller: 3Com Corporation 3c905C-TX/TX-M [Tornado] (rev 78)
Software: SuSE Linux 10.0 Professional with current patches plus self-compiled kernel 2.6.18-rc7-mm1
Thanks
Tilman
Signature · 4 lines
Tilman Schmidt E-Mail: [email protected] Bonn, Germany Diese Nachricht besteht zu 100% aus wiederverwerteten Bits. Ungeöffnet mindestens haltbar bis: (siehe Rückseite)
Quoted 2 lines · /me
When booting kernel 2.6.18-rc7-mm1 on my SuSE Linux 10.0 system, setup of the Ethernet interface fails.
Just re-tested with release 2.6.18-mm1 and the problem is gone.
Thanks
Tilman
Signature · 4 lines
Tilman Schmidt E-Mail: [email protected] Bonn, Germany Diese Nachricht besteht zu 100% aus wiederverwerteten Bits. Ungeoeffnet mindestens haltbar bis: (siehe Rueckseite)