bcm43xx: Drain TX status before starting IRQs
Subsystems (3)
PATCH 1/1 bcm43xx: Drain TX status before starting IRQs
From: Michael Buesch <[email protected]>
Drain the Microcode TX-status-FIFO before we enable IRQs. This is required, because the FIFO may still have entries left from a previous run. Those would immediately fire after enabling IRQs and would lead to an oops in the DMA TXstatus handling code.
Signed-off-by Michael Buesch <[email protected]>
Signed-off-by Larry Finger <[email protected]>
---
drivers/net/wireless/bcm43xx/bcm43xx_main.c +18 -0
@@ -1463,6 +1463,23 @@ static void handle_irq_transmit_status(s } } +static void drain_txstatus_queue (struct bcm43xx_private *bcm) +{ +u32 dummy; + +if (bcm->current_core->rev <5 ) +return ; +/* Read all entries from the microcode TXstatus FIFO +* and throw them away. +*/ +while (1 ) { + dummy =bcm43xx_read32 (bcm, BCM43xx_MMIO_XMITSTAT_0); +if (!dummy) +break ; + dummy =bcm43xx_read32 (bcm, BCM43xx_MMIO_XMITSTAT_1); + } +} +static void bcm43xx_generate_noise_sample (struct bcm43xx_private *bcm) {bcm43xx_shm_write16 (bcm, BCM43xx_SHM_SHARED,0x408 ,0x7F7F );
@@ -3517,6 +3534,7 @@ int bcm43xx_select_wireless_core(structbcm43xx_macfilter_clear (bcm, BCM43xx_MACFILTER_ASSOC);bcm43xx_macfilter_set (bcm, BCM43xx_MACFILTER_SELF, (u8 *)(bcm->net_dev->dev_addr));bcm43xx_security_init (bcm); +drain_txstatus_queue (bcm);ieee80211softmac_start (bcm->net_dev);/* Let's go! Be careful after enabling the IRQs.