OProfile for Cell: Initial profiling support
RFC PATCH 1/2 OProfile for Cell: Initial profiling support
Utility macros, declarations, etc, to support Oprofile for Cell.
Signed-off-by Maynard Johnson <[email protected]>
arch/powerpc/oprofile/cell/perf_utils.h new file +113 -0
@@ -0,0 +1,113 @@ +/* +* perf_utils.h +* +* This file contains useful macros, declarations, etc. used +* by OProfile for the Cell Broadband Engine. +* +* (C) Copyright IBM Corporation 2006 +* +* Authors: Maynard Johnson <[email protected]> +*/ + +#ifndef PERF_UTILS_H +#define PERF_UTILS_H + +#define UNUSED_WORD ~0 + +/* This macro should be used with care as it NR_CPUS is +* a maximum value that may not be accurate at runtime. +*/ +#define NR_NODES (NR_CPUS >> 1) + +/* FIXME: I don't know if there's a _real_ macro or +* function for determining whether or not SMT is enabled. +*/ +#define is_smt () 1 + +#define PPU_CYCLES_EVENT_NUM 1/* event number for PPU_CYCLES */ +#define CBE_COUNT_ALL_CYCLES 0x42800000/* PPU cycle event specifier */ + +#define NUM_THREADS 2 +#define NUM_CNTRS 4 +#define VIRT_CNTR_SW_TIME_NS 100000000 // 0.5 seconds + +#define CBE_COUNT_SUPERVISOR_MODE 0 +#define CBE_COUNT_HYPERVISOR_MODE 1 +#define CBE_COUNT_PROBLEM_MODE 2 +#define CBE_COUNT_ALL_MODES 3 + +/* Macros for the pm07_control registers. */ +#define PM07_CTR_INPUT_MUX (x) ((((x) & 1) << 26) & 0x3f) +#define PM07_CTR_INPUT_CONTROL (x) (((x) & 1) << 25) +#define PM07_CTR_POLARITY (x) (((x) & 1) << 24) +#define PM07_CTR_COUNT_CYCLES (x) (((x) & 1) << 23) +#define PM07_CTR_ENABLE (x) (((x) & 1) << 22) + + +struct pmc_cntrl_data { +unsigned long vcntr; +unsigned long evnts; +unsigned long masks; +unsigned long enabled; +}; + +/* +* ibm,cbe-perftools rtas parameters +*/ + +struct pm_signal { +u16 cpu;/* Processor to modify */ +u16 sub_unit;/* hw subunit this applies to (if applicable) */ +u16 signal_group;/* Signal Group to Enable/Disable */ +u8 bus_word;/* Enable/Disable on this Trace/Trigger/Event +Bus Word(s) (bitmask) */ +u8 bit;/* Trigger/Event bit (if applicable) */ +}; + +/* +* rtas call arguments +*/ +enum { +SUBFUNC_RESET =1 , +SUBFUNC_ACTIVATE =2 , +SUBFUNC_DEACTIVATE =3 , + +PASSTHRU_IGNORE =0 , +PASSTHRU_ENABLE =1 , +PASSTHRU_DISABLE =2 , +}; + +struct pm_cntrl { +short int enable; +short int stop_at_max; +short int trace_mode; +short int freeze; +short int count_mode; +}; + +static struct { +u32 group_control; +u32 debug_bus_control; +struct pm_cntrl pm_cntrl; +u32 pm07_cntrl[OP_MAX_COUNTER ]; +} pm_regs; + +struct oprofile_umask { +union { +u32 val; +struct { +u32 pad1:16 ; +u32 sub_unit:4 ; +u32 pad2:2 ; +u32 bus_type:2 ; +u32 bus_word:4 ; +u32 pad3:1 ; +u32 input_control:1 ; +u32 polarity:1 ; +u32 count_cycles:1 ; + }; + }; +}; + + +#endif // PERF_UTILS_H