Skip to contentSkip to conversation

regarding VIA quirk fix

DISCUSSION Tejun Heo 3 participants 3 messages Nov 17, 2006

lore
Share & tools
lore
#1 lore raw
Quoted 3 lines · On Fri, 17 Nov 2006 19:13:24 +0900 Tejun Heo <[email protected]> wrote:

http://bugzilla.kernel.org/show_bug.cgi?id=7415

Any ideas how to proceed on this bug?

The report appears to be about the earlier patch not the one I did from reading it. That said I don't see it matters which.

The only way to track down any remaining ones is to go line by line through the PCI configuration and understand what we or the bios mixed up so its pretty tedious but doable assuming the bug isn't in the SATA driver in the first place. The IRQ routing on the later chips is pretty rigid so its not too hard to spot a misconfiguration.

Alan

#2 lore raw
In reply to Tejun Heo
Quoted 11 lines · Tejun Heo

Hello, Alan.

We've been getting bug reports from sata_via users for quite sometime now. The first IRQ driven command (IDENTIFY) times out and thus device detection fails. The following patch seems to fix it for many users.

http://marc.theaimsgroup.com/?l=linux-kernel&m=116300291505638

But, not for all.

http://bugzilla.kernel.org/show_bug.cgi?id=7415

Any ideas how to proceed on this bug?

I'm not certain, but I think that this is an unrelated issue. Both the working kernel and the failing kernels quirk the device in the same way:

PCI: VIA IRQ fixup for 0000:00:0f.0, from 11 to 2

Both the working kernel (2.6.17-gentoo-r8) and the first failing kernel (2.6.18-gentoo) have the same patch for 'fixing' the quirk issues: Chris's changes were reverted, the VIA IRQ quirk was back in the 2.6.16 state. Since then the same issues have been observed with unpatched 2.6.19-rc.

This is not definitive but suggests the issue is elsewhere.

Daniel