Skip to contentSkip to conversation

Writting file error no space left (35% used)

NAND-JFFS2 Fabian Rami 1 participant 1 message Jan 4, 2007 Memory technology devices (MTD)

lore
Share & tools
lore
#0 lore raw

Hi all ,

I try to make JFFS2 File system working on a embedded device. This device had 2M0 of Ram and 16 Mo of NAND flash. Here you have the boot sequence information:

   [21474538.190000] S3C24XX NAND Driver, (c) 2004 Simtec Electronics
   [21474538.200000] s3c2410-nand: mapped registers at c1200000
   [21474538.205000] 80 ns is too big for current clock rate 100000000
   [21474538.210000] 80 ns is too big for current clock rate 100000000
   [21474538.215000] 80 ns is too big for current clock rate 100000000
   [21474538.220000] s3c2410-nand: timing: Tacls 419ns, Twrph0 419ns,
   Twrph1 419ns
   [21474538.225000] NAND device: Manufacturer ID: 0xec, Chip ID: 0x73
   (Samsung NAND 16MiB 3,3V 8-bit)
   [21474538.230000] Scanning device for bad blocks
   [21474538.275000] Creating 3 MTD partitions on "NAND 16MiB 3,3V 8-bit":
   [21474538.280000] 0x00000000-0x00040000 : "UBoot"
   [21474538.285000] mtd: Giving out device 0 to UBoot
   [21474538.295000] 0x00040000-0x00160000 : "Kernel"
   [21474538.300000] mtd: Giving out device 1 to Kernel
   [21474538.315000] 0x00160000-0x01000000 : "FileSystem"
   [21474538.320000] mtd: Giving out device 2 to FileSystem

When i use a little soft who made 1000 file of size 1024 i get a OOMKiller.

when i made a df after the oomkiller i see the following :

   root@akt:~# df
   Filesystem           1k-blocks      Used Available Use% Mounted on
   /dev/mtdblock2           14976      5228      9748  35% /
   /dev/ram1                  115        15       100  13% /var

As we can see , we are not going out of space on the flash device.

Is there a problem with the way i make the jffs2 Image ? Here is the way i do it :

      ./mkfs.jffs2 --root=/AktImageDirectory --output=Akt.jffs2 -e 

0x4000 --pad=0x00EA0000 -n

Is there something else to do ?
Have i something to care of the flash_erase if i use dd for install the image ? The install command is :

dd if=/Akt.jffs2 of=/dev/mtdblock2

I am lost!!!

Greetings,

Fabian Rami