Skip to contentSkip to conversation

Experimental driver for Ricoh Bay1Controller SD Card readers

DISCUSSION Ivan Babkin 2 participants 2 messages Feb 15, 2007 – Mar 9, 2007

lore
Share & tools
lore
#0 lore raw

Hi!

Quoted 7 lines

Apart from that I did the following changes:
- implemented suspend/resume support (not tested very much)
- named the registers
- fixed a bug that caused a major slowdown when modprobed without debug=1
- added writting support (disabled by default, modprobe with write=1) Before you enable writting please make sure that you did a proper backup of the data on the card. Do not use this driver to save important data.

Thank for the job you've done!
Your driver works with 1 Gb sd-card (x86_64 suse's 2.16.18.2 kernel). Read rate for me was around 250 Kb/s, write - 28 Kb/s (using dd utility). BTW, I get continuous flow of "sdricoh_cs: timeout waiting for data" messages in dmesg.

Good luck!

#1 lore raw
Quoted 5 lines · Ivan Babkin

Thank for the job you've done!
Your driver works with 1 Gb sd-card (x86_64 suse's 2.16.18.2 kernel). Read rate for me was around 250 Kb/s, write - 28 Kb/s (using dd utility). BTW, I get continuous flow of "sdricoh_cs: timeout waiting for data" messages in dmesg.

Works for me too. Using a 512mb SD card, and a 256miniSD in an adaptor.

Managed to mount both SD cards and play mp3's off each with mpg321. Literally music to my ears. I used the 0.1 release on the homepage, so it still oopsed on removal when I hadnt unmounted.

Laptop is an Acer Travelmate 370 for the record.

James

Signature · 1 line
iphitus // Arch Developer // kernel26beyond // iphitus.loudas.com