Skip to contentSkip to conversation

Sata marvel kernel module

DISCUSSION Pillar Engineering 2 participants 3 messages Mar 8, 2007 libata

lore
Share & tools
lore
#0 lore raw

Hi, i'm working in a project and I use the Marvell 88SE6145 sata controller.
I use the sata_mv module for the linux kernel and, untill now, version 2.6.20.1, it supports only the first two ports on the controller.

Do you know when it will be ready the support for the other two ports?

Thank you very much !!

P.S. I'd like helping programming, but I've never write for the kernel, and in this moment I've no time to learn how to do it.

Signature · 7 lines
Pillar Engineering
di Sanfelici Claudio
Via Cardinal Ferrari 23 / B
Cernusco sul Naviglio - MI
P.Iva 05403820961
Cell. +39 333.14.27.805
E-Mail [email protected]
#1 lore raw
Quoted 2 lines · Pillar Engineering

Hi, i'm working in a project and I use the Marvell 88SE6145 sata controller.
I use the sata_mv module for the linux kernel and, untill now, version 2.6.20.1, it supports only the first two ports on the controller.

sata_mv does not support your hardware at all. The PCI ID is not present, so it won't even load for your hardware without modification.

For the time being, look around for the ahci.c patch I posted, which enables the SATA portion of the 6145.

Jeff

#2 lore raw

Thank you very much for your answer, but I don't understand.

It this moment I use the Vanilla kernel (2.6.20.1) and I can work with the first two sata ports on the controller. Do you mean is not the sata_mv module wich permit this?
Where I can find your patch?

Thanks

Pillar Engineering
di Sanfelici Claudio
Via Cardinal Ferrari 23 / B
Cernusco sul Naviglio - MI
P.Iva 05403820961
Cell. +39 333.14.27.805
E-Mail [email protected]

Jeff Garzik ha scritto:

Quoted 13 lines
Quoted 2 lines · Pillar Engineering

Hi, i'm working in a project and I use the Marvell 88SE6145 sata controller.
I use the sata_mv module for the linux kernel and, untill now, version 2.6.20.1, it supports only the first two ports on the controller.

sata_mv does not support your hardware at all. The PCI ID is not present, so it won't even load for your hardware without modification.

For the time being, look around for the ahci.c patch I posted, which enables the SATA portion of the 6145.

Jeff