Atmel ATNGW100 config file anyone?

Greetings

The subject says it all really!!

I've applied the u-boot-1.1.6-hs1.patch from avrforums to git head (no errors, just a couple of offset & fuzzy matches) so I'm hoping to be able to build a u-boot image with networking for the new avr32 demo board.

The board is on order but I don't know what to expect by way of pre-loaded firmware - especially what capabilities it will have.

Any pointers gratefully received:-)

Robin

=======================================================================
This email, including any attachments, is only for the intended
addressee.  It is subject to copyright, is confidential and may be
the subject of legal or other privilege, none of which is waived or
lost by reason of this transmission.
If the receiver is not the intended addressee, please accept our
apologies, notify us by return, delete all copies and perform no
other act on the email.
Unfortunately, we cannot warrant that the email has not been
 altered or corrupted during transmission.
=======================================================================

You will get a board with U-Boot / Linux / Root filesystem but all the S/W is inside the AVR32 BSP 2.0
which is downloadable from www.atmel.com (or soon will be) There is no CD included in the kit.

I think that the BSP should contain the needed config file.

Best Regards
Ulf Samuelsson ulf at atmel.com
Atmel Nordic AB

Mail:  Box 2033, 174 02 Sundbyberg, Sweden
Visit:  Kavalleriv?gen 24, 174 58 Sundbyberg, Sweden

Phone +46 (8) 441 54 22 Fax +46 (8) 441 54 29
GSM +46 (706) 22 44 57

Technical support when I am not available:
AT90 AVR Applications Group: mailto:avr at atmel.com AT91 ARM Applications Group: mailto:at91support at atmel.com
AVR32 Applications Group mailto:avr32 at atmel.com
http://www.avrfreaks.net/; http://avr32linux.org/
http://www.at91.com/ ; ftp://at91dist:distrib at 81.80.104.162/