Old bug in tg3 driver unfixed?
Hello!
I am not subscribed to this list so please CC answers to my mail address. THX!
I recently replaced the mainboard of one of my servers with a Tyan Tomcat K8E. The onboard gigabit NIC is a Broadcom BCM5721. After compiling and loading the tg3 driver in Kernel 2.6.21.5, the interface could not be configured: "Device not found".
While searching the net i found a few other people with the same problem but no solution.
By coincidence i found that a simpe "ifconfig eth1" worked OK and afterwards the device could be configured and used as desired. After searching this list, i found this posting
http://uwsg.iu.edu/hypermail/linux/kernel/0409.0/0224.html
by someone with obviously the same problem.
Has some patch of the driver been reversed or is the hardware buggy?
BTW the chip is connected via PCI Express.
timbo
Quoted 11 lines · Tim Boneko
Hello!
I am not subscribed to this list so please CC answers to my mail address. THX!I recently replaced the mainboard of one of my servers with a Tyan Tomcat K8E. The onboard gigabit NIC is a Broadcom BCM5721. After compiling and loading the tg3 driver in Kernel 2.6.21.5, the interface could not be configured: "Device not found".
While searching the net i found a few other people with the same problem but no solution.
Quoted 4 lines
By coincidence i found that a simpe "ifconfig eth1" worked OK and afterwards the device could be configured and used as desired. After searching this list, i found this posting
Probably unrelated, but what's eth0?
Quoted 7 lines
http://uwsg.iu.edu/hypermail/linux/kernel/0409.0/0224.html
by someone with obviously the same problem.
Has some patch of the driver been reversed or is the hardware buggy?BTW the chip is connected via PCI Express.
I have that chip in a system, but I didn't find it quickly, it may be at another location, unless the controller which shows up as 3C940 on my ASUS P4P800 is the Broadcom.
Signature · 3 lines
Bill Davidsen <[email protected]> "We have more to fear from the bungling of the incompetent than from the machinations of the wicked." - from Slashdot
Hello list & Bill,
Quoted 1 line · Bill Davidsen
Probably unrelated, but what's eth0?
An additional pci NIC. The second Broadcom NIC of the mainboard doesn't even show up in lspci, no matter how the relevant jumper on the board is set.
timbo
Quoted 11 lines · Tim Boneko
Hello!
I am not subscribed to this list so please CC answers to my mail address. THX!I recently replaced the mainboard of one of my servers with a Tyan Tomcat K8E. The onboard gigabit NIC is a Broadcom BCM5721. After compiling and loading the tg3 driver in Kernel 2.6.21.5, the interface could not be configured: "Device not found".
While searching the net i found a few other people with the same problem but no solution.
Quoted 7 lines
By coincidence i found that a simpe "ifconfig eth1" worked OK and afterwards the device could be configured and used as desired. After searching this list, i found this posting
http://uwsg.iu.edu/hypermail/linux/kernel/0409.0/0224.html
by someone with obviously the same problem.
Sounds more like a iftab/udev problem. Check /etc/iftab and your udev rules please.
Björn
Quoted 2 lines · Björn Steinbrink
Sounds more like a iftab/udev problem. Check
/etc/iftaband your udev rules please.
The MAC address in /etc/iftab matches that of the card. However, there are three rules in /etc/udev/rules.d/z25_persistent-net.rules dealing with eth0 - eth2, they state MAC addresses which don't match. I certainly didn't put them there. Does udev change its own config?
I will have to check the success when i'm back on location. No use in decativating the NIC in a ssh session ;-)
Thanks for the hint,
Tim
Quoted 3 lines · Tim Boneko
are three rules in
/etc/udev/rules.d/z25_persistent-net.rulesdealing with eth0 - eth2, they state MAC addresses which don't match. I certainly didn't put them there. Does udev change its own config?
In Debian, yes. Read the ones with "generator" in the name.
Signature · 4 lines
"One disk to rule them all, One disk to find them. One disk to bring them all and in the darkness grind them. In the Land of Redmond where the shadows lie." -- The Silicon Valley Tarot Henrique Holschuh
Quoted 3 lines · Henrique de Moraes Holschuh
Quoted 1 line
Does udev change its own config?
In Debian, yes. Read the ones with "generator" in the name.
Hey, what a bastard. Never would have guessed that...
Thanks to all & sorry for picking your brains,
timbo