Skip to contentSkip to conversation

Gericom Webboy Laptop Mouse/Touchpad

DISCUSSION Daniel Mierswa 1 participant 1 message Aug 1, 2007

lore
Share & tools
lore
#0 lore raw

First of all, thanks for the quick response.

Quoted 4 lines

Or maybe run oprofile to try to figure out any abnormal system load?

vmstat may provide some initial information as to what kind of activity exactly causes this issue.

I'm sorry. I'm not familar with those applications to get any useful information out of them. Any quick information on what i should be doing with it would be appreciated.

Quoted 8 lines

Hmm, I'm pondering what I'd do here...
Could it be that you're using the "old" IDE layer (not libata yet) and hdparm -u or -d or -c is inconveniently set up?

Try configuring a different CONFIG_HZ?

And did you try running a "barebone"-only configuration? Possibly some certain driver is causing this misbehaviour...

I'm already keeping the config as clean and minimal as i can imagine.

Anyway... I recompiled the kernel (2.6.22.2 now) with pure libata, CONFIG_HZ to 1000 (instead of 250). No effect yet.

Quoted 2 lines

Or maybe it's a simple X.org scheduling issue again? What nice value do you run X.org at?

I'm using the default niceness which should be 10 no? I'm not re-nicing X if that was the question.

Quoted 4 lines

In this context it would be good to ask about possible memory pressure on this system, too, since recently some people indicated more fluid X.org mouse pointer operation when mlocking the pointer handling code to avoid paging this code.

Well the system is low on memory (312M) but that was the last thing i would've been looking for since it somehow got the win32 gui and some games to render and work properly on it.

Quoted 1 line

Maybe run powertop to identify timer anomalies?

This shows two interesting lines:
56.5% ( 21.6) <interrupt> : extra timer interrupt
11.0% ( 4.2) <interrupt> : libata

Quoted 2 lines

Oh, given that IIRC the Webboy is a slightly older Gericom model which thus may easily be a (somewhat hotter) P4 *desktop* CPU

It's a pentium-3.

  model name      : Pentium III (Coppermine)
  stepping        : 10
  cpu MHz         : 1097.269
Quoted 4 lines

could it be that
you're hitting thermal emergency throttling on increased system activity? cat /proc/acpi/processor/*/throttling or something there might indicate this.

When am I supposed to check this? During idle it's like the following:
state count: 8
active state: T0
states:

     *T0:                  00%
      T1:                  12%
      T2:                  25%
      T3:                  37%
      T4:                  50%
      T5:                  62%
      T6:                  75%
      T7:                  87%

Any additional comments on this? :)
Thanks a lot.

Signature · 2 lines
MfG
Mierswa, Daniel