Skip to contentSkip to conversation

- usb power switch

PATCH In review John Crispin 2 participants 2 messages Aug 3, 2007 – Aug 4, 2007 MIPS

lore
Share & tools
lore

John Crispin

author
#0 lore raw

PATCH 1/1 - usb power switch

the gpio of the usb power switch for the mtx-1 is not pulled high due to wrong #ifdef

Signed-off-by John Crispin <[email protected]>
Signed-off-by Felix Fietkau <[email protected]>
arch/mips/au1000/mtx-1/board_setup.c +0 -0
@@ -54,7 +54,7 @@

void __init board_setup(void)
{
-#ifdef CONFIG_USB_OHCI
+#if defined(CONFIG_USB_OHCI_HCD) || defined(CONFIG_USB_OHCI_HCD_MODULE)

	// enable USB power switch
	au_writel( au_readl(GPIO2_DIR) | 0x10, GPIO2_DIR );
	au_writel( 0x100001, GPIO2_OUTPUT );
#1 lore raw

On Fri, Aug 03, 2007 at 11:59:31PM +0200, John Crispin wrote:

Patch doesn't apply.