Skip to contentSkip to conversation

Serial port loging

Buildroot Johnnie Peters 1 participant 2 messages Aug 29, 2007 – Sep 4, 2007

lore
Share & tools
lore
#0 lore raw

Hi All,

I am building a buildroot environment for the CM-X270 board. I have it defined to use "arm" "xscale" and "EABI". I have added a getty for ttySA0 into the inittab and now I get a login prompt on the serial port. I see that the "root" login has a blank password field int he /etc/shadow file so I expected it to just login in when I enter root.

Instead it pauses for a few seconds and displays the login prompt again. I then set up the shutdown login to run reboot. When I tried this I got an error that indicated it was not being ran as root so I set the owner ID of shutdown in the /etc/passwd file to be 0. Now when I try to login as shutdown it also pauses for a few seconds and then displays the login prompt again.

Any ideas?

Thanks for any info,

Johnnie

#1 lore raw

Hi All,

The problem was /dev/ttySA0 was not in the /etc/securetty file.

Johnnie

Quoted 27 lines · Johnnie Peters

Hi All,

I am building a buildroot environment for the CM-X270 board. I have it defined to use "arm" "xscale" and "EABI". I have added a getty for ttySA0 into the inittab and now I get a login prompt on the serial port. I see that the "root" login has a blank password field int he /etc/shadow file so I expected it to just login in when I enter root.

Instead it pauses for a few seconds and displays the login prompt again. I then set up the shutdown login to run reboot. When I tried this I got an error that indicated it was not being ran as root so I set the owner ID of shutdown in the /etc/passwd file to be 0. Now when I try to login as shutdown it also pauses for a few seconds and then displays the login prompt again.

Any ideas?

Thanks for any info,

Johnnie

_______________________________________________
buildroot mailing list
buildroot at uclibc.org
http://busybox.net/mailman/listinfo/buildroot