file system for solid state disks
Hi,
It's important to note that disk-replacement type SSDs perform much better with very small block operations, generally 512 bytes. So the lower your file system block size, the better -- this will be the single most significant performance tweak one should do. This is true for the benchmarks I've seen where the difference between 4KB and 512Byte block sizes was almost 100%. YMMV -- always benchmark.
On SSDs which contain built in wear leveling, pretty much any file system can be used. For SSDs that lack such low level housekeeping, use stuff like JFFS2.
Marc
Quoted 4 lines · Just Marc
On SSDs which contain built in wear leveling, pretty much any file system can be used. For SSDs that lack such low level housekeeping, use stuff like JFFS2.
The question is, how can you find out whether it does automatic wear-leveling? (Perhaps when a CF is advertised as "holds 10 years!"?)
Jan
One must consult the documentation of that device. This wear leveling is low level and most devices do not export any information about it. Recent SSDs start to export some values through SMART that let you monitor the state.
Some companies think that hiding is better than exposing...
Quoted 10 lines · Jan Engelhardt
Quoted 2 lines · Just Marc
On SSDs which contain built in wear leveling, pretty much any file system can be used. For SSDs that lack such low level housekeeping, use stuff like JFFS2.
The question is, how can you find out whether it does automatic wear-leveling? (Perhaps when a CF is advertised as "holds 10 years!"?)
Jan