prevent kswapd from freeing excessive amounts of lowmem
Subsystems (3)
PATCH 1/1 prevent kswapd from freeing excessive amounts of lowmem
The current VM can get itself into trouble fairly easily on systems with a small ZONE_HIGHMEM, which is common on i686 computers with 1GB of memory.
On one side, page_alloc() will allocate down to zone->pages_low, while on the other side, kswapd() and balance_pgdat() will try to free memory from every zone, until every zone has more free pages than zone->pages_high.
Highmem can be filled up to zone->pages_low with page tables, ramfs, vmalloc allocations and other unswappable things quite easily and without many bad side effects, since we still have a huge ZONE_NORMAL to do future allocations from.
However, as long as the number of free pages in the highmem zone is below zone->pages_high, kswapd will continue swapping things out from ZONE_NORMAL, too!
Sami Farin managed to get his system into a stage where kswapd had freed about 700MB of low memory and was still "going strong".
The attached patch will make kswapd stop paging out data from zones when there is more than enough memory free. We do go above zone->pages_high in order to keep pressure between zones equal in normal circumstances, but the patch should prevent the kind of excesses that made Sami's computer totally unusable.
Please merge this into -mm.
mm/vmscan.c renamed from mm/vmscan.c.excessive +7 -1
@@ -1371,7 +1371,13 @@ loop_again: temp_priority[i] = priority; sc.nr_scanned =0 ;note_zone_scanning_priority (zone, priority); - nr_reclaimed +=shrink_zone (priority, zone, &sc); +/* +* We put equal pressure on every zone, unless one +* zone has way too many pages free already. +*/ +if (!zone_watermark_ok (zone, order,8 *zone->pages_high, + end_zone,0 )) + nr_reclaimed +=shrink_zone (priority, zone, &sc); reclaim_state->reclaimed_slab =0 ; nr_slab =shrink_slab (sc.nr_scanned,GFP_KERNEL , lru_pages);
Andrew Morton
maintainerQuoted 10 lines · On Wed, 05 Sep 2007 19:01:25 -0400 Rik van Riel <[email protected]> wrote:
The current VM can get itself into trouble fairly easily on systems with a small
ZONE_HIGHMEM, which is common on i686 computers with 1GB of memory.On one side,
page_alloc()will allocate down tozone->pages_low, while on the other side,kswapd()andbalance_pgdat()will try to free memory from every zone, until every zone has more free pages thanzone->pages_high.
Quoted 8 lines
Highmem can be filled up to
zone->pages_lowwith page tables, ramfs, vmalloc allocations and other unswappable things quite easily and without many bad side effects, since we still have a hugeZONE_NORMALto do future allocations from.However, as long as the number of free pages in the highmem zone is below
zone->pages_high, kswapd will continue swapping things out fromZONE_NORMAL, too!
crap. I guess suitably-fashioned mlock could do the same thing.
Quoted 5 lines
Sami Farin managed to get his system into a stage where kswapd had freed about 700MB of low memory and was still "going strong".
The attached patch will make kswapd stop paging out data from zones when there is more than enough memory free.
hm. Did highmem's all_unreclaimable get set? If so perhaps we could use that in some way.
Quoted 18 lines
We do go above
zone->pages_highin order to keep pressure between zones equal in normal circumstances, but the patch should prevent the kind of excesses that made Sami's computer totally unusable.Please merge this into -mm.
Signed-off-by Rik van Riel <[email protected]>[linux-2.6-excessive-pageout.patch text/x-patch (715B)]
mm/vmscan.c renamed from mm/vmscan.c.excessive +0
-1@@ -1371,7 +1371,13 @@ loop_again: temp_priority[i] = priority; sc.nr_scanned =0 ;note_zone_scanning_priority (zone, priority); - nr_reclaimed +=shrink_zone (priority, zone, &sc);
mm/vmscan.c loop_again: · line 1383
Quoted 10 lines
mm/vmscan.c renamed from mm/vmscan.c.excessive +7
-0+/* +* We put equal pressure on every zone, unless one +* zone has way too many pages free already. +*/ +if (!zone_watermark_ok (zone, order,8 *zone->pages_high, + end_zone,0 )) + nr_reclaimed +=shrink_zone (priority, zone, &sc); reclaim_state->reclaimed_slab =0 ; nr_slab =shrink_slab (sc.nr_scanned,GFP_KERNEL , lru_pages);
I guess for a very small upper zone and a very large lower zone this could still put the scan balancing out of whack, fixable by a smarter version of "8*zone->pages_high" but it doesn't seem very likely that this will affect things much.
Why doesn't direct reclaim need similar treatment?
--
To unsubscribe, send a message with 'unsubscribe linux-mm' in the body to [email protected]. For more info on Linux MM,
see: http://www.linux-mm.org/ .
Don't email: <a href=mailto:"[email protected]"> [email protected] </a>
Quoted 6 lines · Andrew Morton
I guess for a very small upper zone and a very large lower zone this could still put the scan balancing out of whack, fixable by a smarter version of "8*zone->pages_high" but it doesn't seem very likely that this will affect things much.
Why doesn't direct reclaim need similar treatment?
Because we only go into the direct reclaim path once every zone is at or below zone->pages_low, and the direct reclaim path will exit once we have freed more than swap_cluster_max pages.
Signature · 9 lines
Politics is the struggle between those who want to make their country the best in the world, and those who believe it already is. Each group calls the other unpatriotic. -- To unsubscribe, send a message with 'unsubscribe linux-mm' in the body to [email protected]. For more info on Linux MM, see: http://www.linux-mm.org/ . Don't email: <a href=mailto:"[email protected]"> [email protected] </a>
Andrew Morton
maintainerQuoted 3 lines · On Thu, 06 Sep 2007 12:38:13 -0400 Rik van Riel <[email protected]> wrote:
Andrew Morton wrote:
(What happened to the other stuff I said?)
Quoted 5 lines
Quoted 5 lines
I guess for a very small upper zone and a very large lower zone this could still put the scan balancing out of whack, fixable by a smarter version of "8*zone->pages_high" but it doesn't seem very likely that this will affect things much.
Quoted 7 lines
Quoted 1 line
Why doesn't direct reclaim need similar treatment?
Because we only go into the direct reclaim path once every zone is at or below
zone->pages_low, and the direct reclaim path will exit once we have freed more thanswap_cluster_maxpages.
hm. Now I need to remember why direct-reclaim does that :(
--
To unsubscribe, send a message with 'unsubscribe linux-mm' in the body to [email protected]. For more info on Linux MM,
see: http://www.linux-mm.org/ .
Don't email: <a href=mailto:"[email protected]"> [email protected] </a>
Quoted 4 lines · Andrew Morton
Quoted 2 lines · On Thu, 06 Sep 2007 12:38:13 -0400 Rik van Riel <[email protected]> wrote:
Andrew Morton wrote:
(What happened to the other stuff I said?)
Mlock can cause the problem too. As for all_unreclaimable, it is ignored when priority == DEF_PRIORITY, balance_pgdat always seems to start in this stage.
Quoted 5 lines
Quoted 5 lines
Quoted 5 lines
I guess for a very small upper zone and a very large lower zone this could still put the scan balancing out of whack, fixable by a smarter version of "8*zone->pages_high" but it doesn't seem very likely that this will affect things much.
Quoted 8 lines
Quoted 6 lines
Quoted 1 line
Why doesn't direct reclaim need similar treatment?
Because we only go into the direct reclaim path once every zone is at or below
zone->pages_low, and the direct reclaim path will exit once we have freed more thanswap_cluster_maxpages.hm. Now I need to remember why direct-reclaim does that :(
This is done so the system does not end up with the first process that goes into page reclaim staying there forever, while the other processes in the system happily consume the pages freed by that poor first process.
There may be other reasons, too.
Signature · 9 lines
Politics is the struggle between those who want to make their country the best in the world, and those who believe it already is. Each group calls the other unpatriotic. -- To unsubscribe, send a message with 'unsubscribe linux-mm' in the body to [email protected]. For more info on Linux MM, see: http://www.linux-mm.org/ . Don't email: <a href=mailto:"[email protected]"> [email protected] </a>
Hi!
Quoted 50 lines
The current VM can get itself into trouble fairly easily on systems
with a smallZONE_HIGHMEM, which is common on i686 computers with
1GB of memory.On one side,
page_alloc()will allocate down tozone->pages_low,
while on the other side,kswapd()andbalance_pgdat()will try
to free memory from every zone, until every zone has more free
pages thanzone->pages_high.Highmem can be filled up to
zone->pages_lowwith page tables,
ramfs, vmalloc allocations and other unswappable things quite
easily and without many bad side effects, since we still have
a hugeZONE_NORMALto do future allocations from.However, as long as the number of free pages in the highmem
zone is belowzone->pages_high, kswapd will continue swapping
things out fromZONE_NORMAL, too!Sami Farin managed to get his system into a stage where kswapd
had freed about 700MB of low memory and was still "going strong".The attached patch will make kswapd stop paging out data from
zones when there is more than enough memory free. We do go abovezone->pages_highin order to keep pressure between zones equal
in normal circumstances, but the patch should prevent the kind
of excesses that made Sami's computer totally unusable.Please merge this into -mm.
Signed-off-by Rik van Riel <[email protected]>
mm/vmscan.c loop_again: · line 1377
Quoted 8 lines
mm/vmscan.c renamed from mm/vmscan.c.excessive +4
-1@@ -1371,7 +1371,13 @@ loop_again: temp_priority[i] = priority; sc.nr_scanned =0 ;note_zone_scanning_priority (zone, priority); - nr_reclaimed +=shrink_zone (priority, zone, &sc); +/* +* We put equal pressure on every zone, unless one +* zone has way too many pages free already. +*/
That does not seem right. Having empty HIGHMEM and full LOWMEM would be very bad, right? We may stop freeing when there's enough LOWMEM free, but not if there's only HIGHMEM free.
Pavel
Signature · 8 lines
(english) http://www.livejournal.com/~pavelmachek (cesky, pictures) http://atrey.karlin.mff.cuni.cz/~pavel/picture/horses/blog.html -- To unsubscribe, send a message with 'unsubscribe linux-mm' in the body to [email protected]. For more info on Linux MM, see: http://www.linux-mm.org/ . Don't email: <a href=mailto:"[email protected]"> [email protected] </a>
Quoted 33 lines · Pavel Machek
Hi!
Quoted 30 lines
The current VM can get itself into trouble fairly easily on systems with a small
ZONE_HIGHMEM, which is common on i686 computers with 1GB of memory.On one side,
page_alloc()will allocate down tozone->pages_low, while on the other side,kswapd()andbalance_pgdat()will try to free memory from every zone, until every zone has more free pages thanzone->pages_high.Highmem can be filled up to
zone->pages_lowwith page tables, ramfs, vmalloc allocations and other unswappable things quite easily and without many bad side effects, since we still have a hugeZONE_NORMALto do future allocations from.However, as long as the number of free pages in the highmem zone is below
zone->pages_high, kswapd will continue swapping things out fromZONE_NORMAL, too!Sami Farin managed to get his system into a stage where kswapd had freed about 700MB of low memory and was still "going strong".
The attached patch will make kswapd stop paging out data from zones when there is more than enough memory free. We do go above
zone->pages_highin order to keep pressure between zones equal in normal circumstances, but the patch should prevent the kind of excesses that made Sami's computer totally unusable.Please merge this into -mm.
Signed-off-by Rik van Riel <[email protected]>
Quoted 15 lines
mm/vmscan.c loop_again: · line 1377
Quoted 11 lines
mm/vmscan.c renamed from mm/vmscan.c.excessive +4
-1@@ -1371,7 +1371,13 @@ loop_again: temp_priority[i] = priority; sc.nr_scanned =0 ;note_zone_scanning_priority (zone, priority); - nr_reclaimed +=shrink_zone (priority, zone, &sc); +/* +* We put equal pressure on every zone, unless one +* zone has way too many pages free already. +*/ That does not seem right. Having empty HIGHMEM and full LOWMEM would be very bad, right? We may stop freeing when there's enough LOWMEM free, but not if there's only HIGHMEM free.
Please read the code this patch applies to.
The check I add conditionalizes the individual
calls to shrink_zone(), so we do not callshrink_zone() for a zone that has a ton of free
pages. We still call shrink_zone() for the
other zones.
Signature · 9 lines
Politics is the struggle between those who want to make their country the best in the world, and those who believe it already is. Each group calls the other unpatriotic. -- To unsubscribe, send a message with 'unsubscribe linux-mm' in the body to [email protected]. For more info on Linux MM, see: http://www.linux-mm.org/ . Don't email: <a href=mailto:"[email protected]"> [email protected] </a>