CPU too old panic on Centrino proc - 2.6.22.6
Please CC any replies; not subscribed to list
I found this thread: http://lkml.org/lkml/2007/5/16/499
but it doesn't seem to apply here (bear in mind that I'm probably not qualified to determine that though :))
On booting a 2.6.22.6 kernel with SMP support, I get a panic immediately:
PANIC: CPU too old for this kernel
This panic does not occur on a non-SMP kernel having almost identical configuration.
This is on a Thinkpad T41:
/proc/cpuinfo --> http://rlworkman.net/cpuinfo
dmesg --> http://rlworkman.net/dmesg
kernel config --> http://rlworkman.net/config-2.6.22.6
The 2.6.21.5 SMP kernels from Slackware 12.0 all boot properly, and the config for this 2.6.22.6 SMP kernel is based on the one from 12.0.
I'm basically reaching for clues at this point -- is this a PEBKAC on my part? What other information would be useful?
(Please CC me on replies)
Thanks,
-RW
Quoted 11 lines · Robby Workman
On booting a 2.6.22.6 kernel with SMP support, I get a panic immediately:
PANIC: CPU too old for this kernel
This panic does not occur on a non-SMP kernel having almost identical configuration.This is on a Thinkpad T41:
/proc/cpuinfo--> http://rlworkman.net/cpuinfo
dmesg --> http://rlworkman.net/dmesg
kernel config --> http://rlworkman.net/config-2.6.22.6
Quoted 5 lines
The 2.6.21.5 SMP kernels from Slackware 12.0 all boot properly, and the config for this 2.6.22.6 SMP kernel is based on the one from 12.0.
I'm basically reaching for clues at this point -- is this a PEBKAC on my part? What other information would be useful?
Most likely you enabled CONFIG_HIGHMEM64G. Banias didn't support PAE.
-Andi
Quoted 13 lines · Andi Kleen
Quoted 11 lines · Robby Workman
On booting a 2.6.22.6 kernel with SMP support, I get a panic immediately:
PANIC: CPU too old for this kernel
This panic does not occur on a non-SMP kernel having almost identical configuration.This is on a Thinkpad T41:
/proc/cpuinfo--> http://rlworkman.net/cpuinfo
dmesg --> http://rlworkman.net/dmesg
kernel config --> http://rlworkman.net/config-2.6.22.6
Quoted 8 lines
Quoted 5 lines
The 2.6.21.5 SMP kernels from Slackware 12.0 all boot properly, and the config for this 2.6.22.6 SMP kernel is based on the one from 12.0.
I'm basically reaching for clues at this point -- is this a PEBKAC on my part? What other information would be useful?
Most likely you enabled
CONFIG_HIGHMEM64G. Banias didn't support PAE.
Thanks, Andi - that was indeed the problem. Of course, things like this are never solved until asked about on a mailing list :)
HIGHMEM4G rather than HIGHMEM64G (not sure why I had that marked), no PAE, and I was using the 64-bit memory/IO (EXPERIMENTAL). Now it's off. A side effect was CONFIG_X86_CMPXCHG64 disappearing from the .config, which I thought might have also been part of the problem based on that other thread.
Either way, thanks for the response!
-RW