question on modifying pte entries

Hi all,

We've got some kernel code that monitors which pages have been dirtied by an application.

The pages are locked in memory, and the system has no swap. Initially we mark the pages clean using ptep_clear_flush_dirty(), then when requested by the app we scanning through the pages and check the dirty bit using pte_dirty(). If it's dirty we store the address and then mark it clean using the same function as above. The above is all done while holding both mm->mmap_sem and mm->page_table_lock.

This worked fine in 2.6.10 but now in 2.6.14 it's giving us problems. Periodically we'll get a page that we know has been dirtied, but it doesn't get detected as such. It appears that once this occurs, that page will never again be detected as dirty.

Does anyone have any ideas what may be happening? Were there any changes in the page table area other than moving to 4-level mappings? Anyone aware of any missing tlb flushes that were fixed later?

Thanks,

Chris

.14 ? ouch that's old... I can't tell you for sure what went in when, also you aren't telling us whether you are using 32 or 64 bits kernels and what processor family it is, so it's hard to help you there.

What comes to mind though:

- At one point, a PTE page lock was introduced. You need to take that
instead of the PTL (actually, you may need to take both, I'm not sure). I don't know off hand if 2.6.14 has it already though.

- Flushes are batched on ppc64. There might be something wrong with the
batching... clear_flush_dirty should flush but maybe it's not doing it or something like that... There used to be a subtle race with the batching as well that you may hit, not sure, that's why I reworked it all recently (in .22 or .23 iirc).

- Maybe the VM is messing around and disliking the changes to the PTE
you are doing behind its back ?

Ben.