Skip to contentSkip to conversation

powernow-k8 and non-standard multipliers

DISCUSSION Philip Langdale 2 participants 3 messages Nov 13, 2007 – Nov 15, 2007

lore
Share & tools
lore
#0 lore raw

Hi Mark,

I've just upgraded to an X2 5000+ black edition. This model doesn't have a multiple lock and I tried bumping the multiplier up, which is perfectly stable, but which causes powernow-k8 to fail to load. I also tried with the updated patch you posted at the beginning of october (http://lkml.org/lkml/2007/10/9/224)
which didn't make a difference.

Is it possible to make the driver work in this situation or does a non-standard multipler inherently mean that powernow stops working?

Thanks,

--phil

#1 lore raw
Quoted 10 lines

I've just upgraded to an X2 5000+ black edition. This model doesn't have a multiple lock and I tried bumping the multiplier up, which is perfectly stable, but which causes powernow-k8 to fail to load. I also tried with the updated patch you posted at the beginning of october (http://lkml.org/lkml/2007/10/9/224)
which didn't make a difference.

Is it possible to make the driver work in this situation or does a non-standard multipler inherently mean that powernow stops working?

The standard PowerNow! driver, by design, will stop working in this situation. I'm not going to support a driver that allows non-standard multipliers because it could cause a lot of hard to debug maintenance issues.

-Mark Langsdorf
Operating System Research Center
AMD

#2 lore raw
Quoted 6 lines · Mark

The standard PowerNow! driver, by design, will stop working in this situation. I'm not going to support a driver that allows non-standard multipliers because it could cause a lot of hard to debug maintenance issues.

Just a follow-up to get this into the public record. I discussed this with Mark privately and then did more digging and established that in my particular case, the problem was that the BIOS was hiding the p-state table when a non-standard multiplier was used. So, I built a custom DSDT that included the p-state table along with an extra entry for my higher speed and now I've happily got powernow support again.

--phil