Skip to contentSkip to conversation

[2.6.22.1] spurious (?) message "BUG: lock held at task exit time"

DISCUSSION Tilman Schmidt 1 participant 2 messages Jul 18, 2007 – Dec 13, 2007

lore
Share & tools
lore
#0 lore raw

When testing the serial Gigaset driver with kernel release 2.6.22.1 I get a kernel BUG message:

=====================================
[ BUG: lock held at task exit time! ]
-------------------------------------
gigasetm101d/5970 is exiting with locks still held!
1 lock held by gigasetm101d/5970:
#0: (&cs->hw.ser->dead_mutex){--..}, at: [<c02d8bc7>] mutex_lock+0x1c/0x1f

which is all well and true except the process that has exited is the grandfather process of a daemon() call, and the daemonized grandchild process is still running happily, keeping the serial device open and ensuring the line discipline stays loaded, and therefore legally holding the dead_mutex:

ts@xenon:~> ps lw 5992

F   UID   PID  PPID PRI  NI    VSZ   RSS WCHAN  STAT TTY        TIME COMMAND
1     0  5992     1  16   0   1432   168 pause  S    ?          0:00 ./gigaset/driver/daemon/gigasetm101d /dev/ttyS0

The structure of gigasetm101d is basically:

    if ((tty_fd = open(dev, O_RDWR|O_NOCTTY)) < 0) {
        fprintf(stderr, "%s: cannot open %s: %s\n", prog, dev, strerror(errno));
        exit(EXIT_FAILURE);
    }
    if (ioctl(tty_fd, TIOCSETD, &ldisc) < 0)
    {
        fprintf(stderr, "%s: cannot set line discipline: %s\n",
                prog, strerror(errno));
        exit(EXIT_FAILURE);
    }
    if (daemon (0, 0) != 0)
    {
        fprintf(stderr, "%s: cannot daemonize: %s\n",
                prog, strerror(errno));
        exit(EXIT_FAILURE);
    }
    pause();
    exit(EXIT_SUCCESS);

Who is at fault here?

Thanks,
Tilman

Signature · 4 lines
Tilman Schmidt                    E-Mail: [email protected]
Bonn, Germany
Diese Nachricht besteht zu 100% aus wiederverwerteten Bits.
Ungeöffnet mindestens haltbar bis: (siehe Rückseite)
#1 lore raw
Quoted 9 lines · me myself I

When testing the serial Gigaset driver with kernel release 2.6.22.1 I get a kernel BUG message:

=====================================
[ BUG: lock held at task exit time! ]
-------------------------------------
gigasetm101d/5970 is exiting with locks still held!
1 lock held by gigasetm101d/5970:
#0: (&cs->hw.ser->dead_mutex){--..}, at: [<c02d8bc7>] mutex_lock+0x1c/0x1f

[...]

Quoted 1 line

Who is at fault here?

Ok, I accidentally solved this myself now, so please don't bother answering.

Signature · 4 lines
Tilman Schmidt                          E-Mail: [email protected]
Bonn, Germany
Diese Nachricht besteht zu 100% aus wiederverwerteten Bits.
Ungeöffnet mindestens haltbar bis: (siehe Rückseite)