assigning a line discipline to a serial device from inside the kernel
The Siemens Gigaset M101 driver (drivers/isdn/gigaset/ser_gigaset.ko) is implemented as a serial line discipline N_GIGASET_M101, much like the better-known N_SLIP and N_PPP LDs. It must therefore be "pushed" onto a serial device in order to be used.
The classic approach is a trivial userspace daemon which opens the device, sets the LD via ioctl(~,TIOCSETD,~), and must then sleep indefinitely while keeping the device open, because closing it would unload the LD.
Is there a clean and acceptable way to avoid this userspace daemon and push the LD onto the serial device from within the kernel?
Thanks,
Tilman
Signature · 4 lines
Tilman Schmidt E-Mail: [email protected] Bonn, Germany Diese Nachricht besteht zu 100% aus wiederverwerteten Bits. Ungeöffnet mindestens haltbar bis: (siehe Rückseite)