Skip to contentSkip to conversation

: Use proc_create() to setup ->proc_fops first

PATCH Applied Wang Chen 2 participants 2 messages Feb 28, 2008

Subsystems (2)
Networking Network drivers
lore
Share & tools
lore

Wang Chen

author
#0 lore raw

PATCH 1/15 : Use proc_create() to setup ->proc_fops first

As Davem mentioned in his recently patch
(d9595a7b9c777d45a74774f1428c263a0a47f4c0)
that the procfs visibility should occur after
the ->proc_fops are setup.

And also, Alexey provide proc_create() to make
sure that ->proc_fops is setup before gluing PDE
to main tree.

We use proc_create().

Signed-off-by Wang Chen <[email protected]>
---
 net/appletalk/atalk_proc.c |   15 +++++++--------
 1 files changed, 7 insertions(+), 8 deletions(-)
net/appletalk/atalk_proc.c +7 -8
index 8e8dcfd..162199a 100644
@@ -283,25 +283,24 @@ int __init atalk_proc_init(void)
 		goto out;
 	atalk_proc_dir->owner = THIS_MODULE;
 
-	p = create_proc_entry("interface", S_IRUGO, atalk_proc_dir);
+	p = proc_create("interface", S_IRUGO, atalk_proc_dir,
+			&atalk_seq_interface_fops);
 	if (!p)
 		goto out_interface;
-	p->proc_fops = &atalk_seq_interface_fops;
 
-	p = create_proc_entry("route", S_IRUGO, atalk_proc_dir);
+	p = proc_create("route", S_IRUGO, atalk_proc_dir,
+			&atalk_seq_route_fops);
 	if (!p)
 		goto out_route;
-	p->proc_fops = &atalk_seq_route_fops;
 
-	p = create_proc_entry("socket", S_IRUGO, atalk_proc_dir);
+	p = proc_create("socket", S_IRUGO, atalk_proc_dir,
+			&atalk_seq_socket_fops);
 	if (!p)
 		goto out_socket;
-	p->proc_fops = &atalk_seq_socket_fops;
 
-	p = create_proc_entry("arp", S_IRUGO, atalk_proc_dir);
+	p = proc_create("arp", S_IRUGO, atalk_proc_dir, &atalk_seq_arp_fops);
 	if (!p)
 		goto out_arp;
-	p->proc_fops = &atalk_seq_arp_fops;
 
 	rc = 0;
 out:
Signature · 1 line
WCN
maintainer Applied
#1 lore raw

From: Wang Chen <[email protected]>
Date: Thu, 28 Feb 2008 18:54:51 +0800

Quoted 5 lines

As Davem mentioned in his recently patch
(d9595a7b9c777d45a74774f1428c263a0a47f4c0)
that the procfs visibility should occur after
the ->proc_fops are setup.

Quoted 7 lines

And also, Alexey provide proc_create() to make
sure that ->proc_fops is setup before gluing PDE
to main tree.

We use proc_create().

Signed-off-by Wang Chen <[email protected]>

Applied, thanks.