Some questions concering to TT Connect S-2400

Hi,

I'm very new to linux-dvb. I just bought blinded by salesman a TechniSat SkyStar USB plus and would like to know how I can get this DVB-S receiver working.

I already figured out that it's a TechnoTrend S-2400 originally and I also found a patch posted by Andre Weidemann.

Here's the patch:
http://www.spinics.net/lists/linux-dvb/msg23611.html

I've downloaded from http://ilpss8.dyndns.org/DVB-driver/v4l-dvb/ the latest version of v4l-dvb and patched it.

But there are still some Question:
- Where to place the firmware mentioned in his thread?
- Which module(s) must be loaded after installing?
- And finally how to get the device working?

Please note that I'm completely new to this and I didn't used DVB-S before. Could please also send me some tutorials which I should read after installing the hardware successfully?

Many thanks in advance!!!

Benjamin

_______________________________________________
linux-dvb mailing list
[email protected]
http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb

Hi,

I played a bit with sourcecode and kernel. the technisat skystar usb plus now works fine!
if there's anybody who needs help... just contact me.

This is what dmesg now shows :D

dvb-usb: found a 'TechnoTrend AG' in warm state.
dvb-usb: will pass the complete MPEG2 transport stream to the software demuxer.
DVB: registering new adapter (TechnoTrend AG)
DVB: registering frontend 0 (Philips TDA10086 DVB-S)...
dvb-usb: TechnoTrend AG successfully initialized and connected.

Best regards
benjamin

_______________________________________________
linux-dvb mailing list
[email protected]
http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb