No channels on just some frequencies...
Hi,
I can szap many free channels from Hotbird 13E, but none on some frequencies. For example, if the "test" file just contains the line:
S 11766000 V 27500000 2/3
that I took from http://www.lyngsat.com/hotbird.html as many other which instead work percectly, the command:
scan test > channels.conf
alway gives the following output:
scanning prova
using '/dev/dvb/adapter0/frontend0' and '/dev/dvb/adapter0/demux0' initial transponder 11766000 V 27500000 2
Quoted 1 line
Quoted 1 line
Quoted 1 line
tune to: 11766:v:0:27500
WARNING: >>> tuning failed!!!
Quoted 1 line
Quoted 1 line
Quoted 1 line
tune to: 11766:v:0:27500 (tuning failed)
WARNING: >>> tuning failed!!!
ERROR: initial tuning failed
dumping lists (0 services)
Done.
On the other hand, if I put manually some lines in channels.conf for such a frequency, I can zap to those channels, but in most cases I watch a different channel, not the one I expected to see.
This doesn't happen on other frequencies.
May be of some help the fact that I'm writing from Italy, and I cannot get channels from the scan for the most important italian channels: in particular, none of RAI network, nor Mediaset network, the biggest network in Italy.
Also, the signal became rather good after I bought an amplifier. Actually, I can see and record perfectly fine many channels. I don't think I have signal strength problems.
Any hint will be very much appreciated.
Best regards.
Signature · 6 lines
Andrea _______________________________________________ linux-dvb mailing list [email protected] http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb