SGI Indy looking for a home...
I have an SGI Indy located in San Jose, CA that is looking for a home. Gratis to anyone that will take it away and make good use of it.
This bad boy has a whopping 256MB RAM (The maximum for an Indy I think), and a 1GB + 2GB disks. It also sports an adapter so that you can attach a standard VGA monitor (must have sync on green, Samgung flat panels seem to work, but not my Cornerstone CRT). Hook up standard PS-2 mouse and keyboard (not included), and you are ready to go with this fine MIPS64 system.
Currently it is running Debian, I am not sure the exact clock speed (probably 150MHz) as I don't have a monitor attached to view hwinv. But here is the info I have handy:
daney@indy:~$ cat /proc/cpuinfo system type : SGI Indy processor : 0 cpu model : R4400SC V5.0 FPU V0.0 BogoMIPS : 74.49 wait instruction : no microsecond timers : yes tlb_entries : 48 extra interrupt vector : no hardware watchpoint : yes ASEs implemented : VCED exceptions : 476805 VCEI exceptions : 4876
daney@indy:~$ dmesg Linux version 2.6.18-4-r4k-ip22 (Debian 2.6.18.dfsg.1-12etch2) ([email protected]) (gcc version 4.1.2 20061115 (prerelease) (Debian 4.1.1-21)) #1 Tue May 8 03:48:00 UTC 2007 ARCH: SGI-IP22 PROMLIB: ARC firmware Version 1 Revision 10 CPU revision is: 00000450 FPU revision is: 00000500 MC: SGI memory controller Revision 3 MC: Probing memory configuration: bank0: 128M @ 08000000 bank1: 128M @ 10000000 Determined physical RAM map: memory: 0000000010000000 @ 0000000008000000 (usable)
.
.
.
Calibrating system timer... 300000 [150.0000 MHz CPU]
Using 75.000 MHz high precision timer.
NG1: Revision 6, 24 bitplanes, REX3 revision B, VC2 revision A, xmap9 revision A, cmap revision C, bt445 revision D
NG1: Screensize 1024x768
Console: colour SGI Newport 128x48
.
.
.
eth0: SGI Seeq8003 08:00:69:07:94:d1
wd33c93-0: chip=WD33c93B/13 no_sync=0xff no_dma=0 debug_flags=0x00
setup_args=,,,,,,,,,
Version 1.26 - 22/Feb/2003, Compiled May 8 2007 at 03:26:34scsi0 : SGI WD93
sending SDTR 0103013f0csync_xfer=2c<5> Vendor: SGI Model: SEAGATE ST31230N Rev: 0272
Type: Direct-Access ANSI SCSI revision: 02
sending SDTR 0103013f0csync_xfer=2c<5> Vendor: SGI Model: SEAGATE ST32430N Rev: 0272
Type: Direct-Access ANSI SCSI revision: 02
SCSI device sda: 2070235 512-byte hdwr sectors (1060 MB)
sda: Write Protect is off
sda: Mode Sense: 87 00 10 08
SCSI device sda: drive cache: write through w/ FUA SCSI device sda: 2070235 512-byte hdwr sectors (1060 MB)
sda: Write Protect is off
sda: Mode Sense: 87 00 10 08
SCSI device sda: drive cache: write through w/ FUA
sda: sda1 sda2 sda9 sda11
sd 0:0:1:0: Attached scsi disk sda
SCSI device sdb: 4197405 512-byte hdwr sectors (2149 MB)
sdb: Write Protect is off
sdb: Mode Sense: 87 00 10 08
SCSI device sdb: drive cache: write through w/ FUA SCSI device sdb: 4197405 512-byte hdwr sectors (2149 MB)
sdb: Write Protect is off
sdb: Mode Sense: 87 00 10 08
SCSI device sdb: drive cache: write through w/ FUA
sdb: sdb1 sdb2 sdb9 sdb11
sd 0:0:2:0: Attached scsi disk sdb
daney@indy:~$ cat /proc/partitions major minor #blocks name
8 0 1035117 sda 8 1 851136 sda1 8 2 130944 sda2 8 9 52173 sda9 8 11 1034253 sda11 8 16 2098702 sdb 8 17 1966167 sdb1 8 18 130625 sdb2 8 25 1567 sdb9 8 27 2098360 sdb11