question about circular locking dependency
Hello,
While shutting down 2.6.25 on my VIA EK8000, just before turning off the encrypted swap, I noticed messages about a circular locking dependency rolling over the screen. The messages were not in /var/log/messages after reboot.
The machine did shut down and restart without further problems.
I assume a serial console is the only way to capture the error messages of this circular locking dependency.
Or are there alternatice methods?
Is this specific circular locking dependency a known issue?
Kind regards,
Udo
Quoted 3 lines · Udo van den Heuvel
I assume a serial console is the only way to capture the error messages of this circular locking dependency.
Or are there alternatice methods?
You can try netconsole: see Documentation/networking/netconsole.txt for details on how to set it up. It may not always work. Obviously a failure in the networking code may not be reported correctly. But it will try its best.
I just use netcat on a separate system to listen on a specific port and redirect to a file:
netcat -lu -p 6666 > logfile
This tells netcat to listen, UDP, port 6666.
Then, on the test system, I load the netconsole module with option:
netconsole=@/,@192.168.4.60/00:17:31:98:77:2f
on boot. After this point every kernel message is logged to the logfile via netcat. You can also build netconsole in and specify the options on the boot command line. But if you do this obviously you need to build in your network card driver, as well :)
Hope that helps.
Cheers,
Dan
Signature · 3 lines
/--------------- - - - - - -
| Dan Noé
| http://isomerica.net/~dpn/