Skip to contentSkip to conversation

2.6.24.4 Sonics Silicon Backplane problems in dmesg

DISCUSSION Larry Finger 2 participants 2 messages May 4, 2008 1 message not in the archive

lore
Share & tools
lore

A message that is not in the archive (sent off-list or not yet received): [email protected]

#1 lore raw
Quoted 6 lines · Larry Finger

I'm attempting to bring up a Compaq F752US laptop running Gentoo. The kernel.org 2.6.24.4, Gentoo Vanilla-sources and 2.6.24-gentoo-r4 kernels all fail to boot without selecting the 'noapic' option on the kernel command line. If I add noapic irqpoll the machine does boot but I see this problem for all 3 kernels:

Quoted 7 lines

Is this possibly caused by having to choose the noapic irqpoll options?

<SNIP>

WARNING: at drivers/ssb/main.c:883 ssb_tmslow_reject_bitmask()
Pid: 1, comm: swapper Not tainted 2.6.24-gentoo-r4 #4
[<c0375e3f>] ssb_tmslow_reject_bitmask+0x4b/0x56
[<c0376504>] ssb_device_is_enabled+0x9/0x2d

The warning above is caused by the configuration of the device below. I found and fixed this problem several months ago, but after the 2.6.24 window closed.

Quoted 2 lines

03:00.0 Network controller: Broadcom Corporation BCM94311MCG wlan mini-PCI (rev 02)

The problem is fixed in the wireless-testing.git tree, and in mainline 2.6.25. It is unlikely that it is causing the boot problem; however that could be checked by trying 2.6.25.

Larry

#2 lore raw
Quoted 17 lines · Larry Finger
Quoted 6 lines · Larry Finger

I'm attempting to bring up a Compaq F752US laptop running Gentoo. The kernel.org 2.6.24.4, Gentoo Vanilla-sources and 2.6.24-gentoo-r4 kernels all fail to boot without selecting the 'noapic' option on the kernel command line. If I add noapic irqpoll the machine does boot but I see this problem for all 3 kernels:

Quoted 8 lines

Is this possibly caused by having to choose the noapic irqpoll options?

<SNIP>

WARNING: at drivers/ssb/main.c:883 ssb_tmslow_reject_bitmask()
Pid: 1, comm: swapper Not tainted 2.6.24-gentoo-r4 #4
[<c0375e3f>] ssb_tmslow_reject_bitmask+0x4b/0x56
[<c0376504>] ssb_device_is_enabled+0x9/0x2d
Quoted 5 lines

The warning above is caused by the configuration of the device below. I
found
and fixed this problem several months ago, but after the 2.6.24 window
closed.

Thanks Larry. I downloaded 2.6.25 but hadn't had a chance to build it yet. I'll get on that.

Quoted 10 lines
Quoted 5 lines

03:00.0 Network controller: Broadcom Corporation BCM94311MCG wlan mini-PCI (rev 02)

The problem is fixed in the wireless-testing.git tree, and in mainline
2.6.25. It is unlikely that it is causing the boot problem; however that could be checked by trying 2.6.25.

Yeah, doesn't seem likely. The non-boot issue was earlier in the boot process with messages like these:

Intel machine check architecture supported.
Intel machine check reporting enabled on CPU#1
CPU1: AMD Athlon(tm) 64 X2 Mobile Technology TK-53 stepping 01 Total of 2 processors activated (6834.25 BogoMIPS). ENABLING IO-APIC IRQs
..TIMER: vector=0x31 apic1=0 pin1=2 apic2=-1 pin2=-1

and then it just hangs.

Since I wrote the message this morning I munged through the kernel config and came up with a config file that doesn't hang without the options. I'll send the two config files along to the list under a different subject line that speaks directly to this problem.

Thanks,
Mark