Skip to contentSkip to conversation

linux-next does not find root partition on PATA ICH5

DISCUSSION Sitsofe Wheeler 2 participants 4 messages May 8, 2008 – May 9, 2008

lore
Share & tools
lore
#0 lore raw

Trying to boot a linux-next kernel (git cloned today) never seems to find the root partition. Putting the PATA drivers and ext3 components into the kernel image rather than modules makes no difference. Near enough the same config boots on 2.6.26rc1 (git pulled today).

Apologies for posting this to the main kernel list - the linux-next list doesn't yet appear to be fully on GMANE (
http://dir.gmane.org/gmane.linux.kernel.next ) or Google Groups...

lspci for the IDE interface:
00:1f.1 IDE interface: Intel Corporation 82801EB/ER (ICH5/ICH5R) IDE Controller (rev 02)
00:1f.2 IDE interface: Intel Corporation 82801EB (ICH5) SATA Controller (rev
02)

The kernel config used is on
http://sucs.org/~sits/test/kernel-config-20080508 .

Signature · 1 line
Sitsofe
#1 lore raw
Quoted 9 lines · Sitsofe Wheeler

Trying to boot a linux-next kernel (git cloned today) never seems to find the root partition. Putting the PATA drivers and ext3 components into the kernel image rather than modules makes no difference. Near enough the same config boots on 2.6.26rc1 (git pulled today).

Apologies for posting this to the main kernel list - the linux-next list doesn't yet appear to be fully on GMANE (
http://dir.gmane.org/gmane.linux.kernel.next ) or Google Groups...

Quoted 8 lines

lspci for the IDE interface:
00:1f.1 IDE interface: Intel Corporation 82801EB/ER (ICH5/ICH5R) IDE Controller (rev 02)
00:1f.2 IDE interface: Intel Corporation 82801EB (ICH5) SATA Controller (rev
02)

The kernel config used is on
http://sucs.org/~sits/test/kernel-config-20080508 .

Check out the patch CC'd to you in another thread ("Re: [git patches] libata updates[...]")

Jeff

#2 lore raw
Quoted 2 lines · Jeff Garzik

Check out the patch CC'd to you in another thread ("Re: [git patches] libata updates[...]")

Even after small adaptions to make the patch apply long timeouts persist and the hard disk device node never appears in /dev/ ...

Signature · 1 line
Sitsofe
#3 lore raw
In reply to Jeff Garzik
Quoted 2 lines · Jeff Garzik

Check out the patch CC'd to you in another thread ("Re: [git patches] libata updates[...]")

After trying the patch again this morning I found I mangled it and it does in fact solve the problem I was seeing. Thanks!

Signature · 1 line
Sitsofe