Skip to contentSkip to conversation

Reallocating sd device

DISCUSSION Richard Scobie 1 participant 1 message Jun 9, 2008 MD RAID

lore
Share & tools
lore
#0 lore raw

Testing a 16 SATA drive (/dev/sd[c-r]1), md RAID, with drives installed in a hotswap SAS/SATA enclosure.

Failed out /dev/sdd1, ejected the drive from the enclosure, reinserted it and the system added it back as /dev/sds:

Jun  9 11:24:37 flash2 kernel: mptsas: ioc0: removing sata device, channel 0, id 30, phy 5
Jun  9 11:24:37 flash2 kernel: sd 4:0:1:0: [sdd] Synchronizing SCSI cache
Jun  9 11:24:37 flash2 kernel: sd 4:0:1:0: [sdd] Result: hostbyte=DID_NO_CONNECT driverbyte=DRIVER_OK,SUGGEST_OK
Jun  9 11:26:38 flash2 kernel: mptsas: ioc0: attaching sata device, channel 0, id 30, phy 5
Jun  9 11:26:38 flash2 kernel: scsi 4:0:17:0: Direct-Access     ATA 
 WDC WD7500AYYS-0 4G30 PQ: 0 ANSI: 5
Jun  9 11:26:38 flash2 kernel: sd 4:0:17:0: [sds] 1465149168 512-byte hardware sectors (750156 MB)

Rebooting shows the offline drive back as /dev/sdd.

Is there a safe, (OK to do on a mounted, active array), way of changing the sds back to sdd, prior to adding it back into the array, without having to reboot?

Regards,

Richard