Skip to contentSkip to conversation

8139cp/too support not accessible?

DISCUSSION Elijah Anderson 2 participants 3 messages Jun 12, 2008

lore
Share & tools
lore
#0 lore raw

Hey List,

I will admit right off the bat that I'm new to interacting directly with the kernel, much less building one.

The issue I'm having is that my ethernet card requires either the 8139cp or 8139too module. I don't remember which one, so I want to modularize them both. Problem is, using $make xconfig; I can't select it. I have the interface set to show me all the options, but the modules I need are grayed out and I can't change the value.

Using $make config; It doesn't show them, even if I say Y to "Prompt for development and/or incomplete code/drivers"

Is there a way to manually select those drivers for modularization, or am I just missing a step somewhere?

Thank you.

#1 lore raw
Quoted 11 lines · Elijah Anderson

Hey List,

I will admit right off the bat that I'm new to interacting directly with the kernel, much less building one.

The issue I'm having is that my ethernet card requires either the 8139cp or 8139too module. I don't remember which one, so I want to modularize them both. Problem is, using $make xconfig; I can't select it. I have the interface set to show me all the options, but the modules I need are grayed out and I can't change the value.

Quoted 7 lines

Using $make config; It doesn't show them, even if I say Y to "Prompt for development and/or incomplete code/drivers"

Is there a way to manually select those drivers for modularization, or am I just missing a step somewhere?

Thank you.

That's not really a kernel issue... however, since I have
that configuration (both drivers modular) at home, I know it works :)

You probably haven't selected NET_PCI, which is the
entry described by

"EISA, VLB, PCI and on board controllers"

The drivers you want depend on the above entry being selected.

--alessandro

"Give me love / Or give me hate
Give me anything that's not just ok"

(Sophia, 'Weightless')

#2 lore raw

Thank you. That worked.

Sorry about the confusion, I just didn't know where else to ask. For future reference, what's a better list to ask for that sort of question?

Quoted 37 lines · Alessandro Suardi
Quoted 11 lines · Elijah Anderson

Hey List,

I will admit right off the bat that I'm new to interacting directly with the kernel, much less building one.

The issue I'm having is that my ethernet card requires either the 8139cp or 8139too module. I don't remember which one, so I want to modularize them both. Problem is, using $make xconfig; I can't select it. I have the interface set to show me all the options, but the modules I need are grayed out and I can't change the value.

Quoted 7 lines

Using $make config; It doesn't show them, even if I say Y to "Prompt for development and/or incomplete code/drivers"

Is there a way to manually select those drivers for modularization, or am I just missing a step somewhere?

Thank you.

That's not really a kernel issue... however, since I have
that configuration (both drivers modular) at home, I know it works :)

You probably haven't selected NET_PCI, which is the
entry described by

"EISA, VLB, PCI and on board controllers"

The drivers you want depend on the above entry being selected.

--alessandro

"Give me love / Or give me hate
Give me anything that's not just ok"

(Sophia, 'Weightless')