Fix copper/fiber auto-selection for 88e1111
Subsystems (2)
PATCH 1/2 Fix copper/fiber auto-selection for 88e1111
The 27.15 bit (MII_M1111_HWCFG_FIBER_COPPER_AUTO) is disable bit. When set to 1, copper/fiber auto selection is disabled. The current code to enable but actually disable auto selection.
--- drivers/net/phy/marvell.c | 2 +- 1 files changed, 1 insertions(+), 1 deletions(-)
drivers/net/phy/marvell.c +0 -0
@@ -162,7 +162,7 @@ static int m88e1111_config_init(struct phy_device
*phydev)
/* Enable Fiber/Copper auto selection */ temp = phy_read(phydev, MII_M1111_PHY_EXT_SR);
- temp |= MII_M1111_HWCFG_FIBER_COPPER_AUTO;
+ temp &= ~MII_M1111_HWCFG_FIBER_COPPER_AUTO;
phy_write(phydev, MII_M1111_PHY_EXT_SR, temp);
temp = phy_read(phydev, MII_BMCR);
Signature · 1 line
1.5.5.4
Quoted 8 lines · Wang Jian
The 27.15 bit (
MII_M1111_HWCFG_FIBER_COPPER_AUTO) is disable bit. When set to 1, copper/fiber auto selection is disabled. The current code to enable but actually disable auto selection.Signed-off-by Wang Jian <[email protected]>---
drivers/net/phy/marvell.c| 2 +-1 files changed, 1 insertions(+), 1 deletions(-)
These should really get cc'd to the netdev list.
- k