unknown dvbt device 1ae7:0381 Xtensions 380U

linux-dvb [email protected] 1 participant 1 message Jul 15, 2008 Media (V4L/DVB)

lore

Share & tools

lore

[email protected]

author

2008-07-15 21:01 UTC #0 lore raw

Hello Antti,

this was the solution. It works now quite fine. Thanks a lot for your fast and very good work.

here again the dmesg:

usb 1-6.1: new high speed USB device using ehci_hcd and address 10 usb 1-6.1: configuration #1 chosen from 1 choice
usb 1-6.1: New USB device found, idVendor=1ae7, idProduct=0381 usb 1-6.1: New USB device strings: Mfr=1, Product=2, SerialNumber=0 usb 1-6.1: Product: DVB-T 2
usb 1-6.1: Manufacturer: Afatech
af9015_usb_probe: interface:0
af9015_read_config: IR mode:4
af9015_read_config: TS mode:0
af9015_read_config: [0] xtal:2 set adc_clock:28000
af9015_read_config: [0] IF1:36125
af9015_read_config: [0] MT2060 IF1:5888
af9015_read_config: [0] tuner id:134
af9015_identify_state: reply:01
dvb-usb: found a 'Xtensions XD-380' in cold state, will try to load a firmware
dvb-usb: downloading firmware from file 'dvb-usb-af9015.fw' af9015_download_firmware:
usbcore: registered new interface driver dvb_usb_af9015
usb 1-6.1: USB disconnect, address 10
af9015_usb_device_exit:
dvb-usb: generic DVB-USB module successfully deinitialized and disconnected. usb 1-6.1: new high speed USB device using ehci_hcd and address 11 usb 1-6.1: configuration #1 chosen from 1 choice
af9015_usb_probe: interface:0
af9015_read_config: IR mode:4
af9015_read_config: TS mode:0
af9015_read_config: [0] xtal:2 set adc_clock:28000
af9015_read_config: [0] IF1:36125
af9015_read_config: [0] MT2060 IF1:5888
af9015_read_config: [0] tuner id:134
af9015_identify_state: reply:02
dvb-usb: found a 'Xtensions XD-380' in warm state.
i2c-adapter i2c-3: SMBus Quick command not supported, can't probe for chips
dvb-usb: will pass the complete MPEG2 transport stream to the software demuxer.
DVB: registering new adapter (Xtensions XD-380) af9015_af9013_frontend_attach: init I2C
af9015_i2c_init:
i2c-adapter i2c-4: SMBus Quick command not supported, can't probe for chips 00: 2b f0 9b 0b 00 00 00 00 e7 1a 81 03 00 02 01 02
10: 00 80 00 fa fa 10 40 ef 04 30 31 30 31 30 32 30
20: 32 30 37 30 30 30 30 31 ff ff ff ff ff ff ff ff
30: 00 00 3a 01 00 08 02 00 1d 8d 00 17 86 ff ff ff
40: ff ff ff ff ff 08 02 00 1d 8d c4 04 82 ff ff ff
50: ff ff ff ff ff 26 00 00 04 03 09 04 10 03 41 00
60: 66 00 61 00 74 00 65 00 63 00 68 00 10 03 44 00
70: 56 00 42 00 2d 00 54 00 20 00 32 00 20 03 30 00
80: 31 00 30 00 31 00 30 00 31 00 30 00 31 00 30 00
90: 36 00 30 00 30 00 30 00 30 00 31 00 00 ff ff ff
a0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
b0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
c0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
d0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
e0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
f0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
af9013: chip version:1 ROM version:1.0
af9013: firmware version:4.65.0
DVB: registering frontend 0 (Afatech AF9013 DVB-T)... af9015_tuner_attach:
Quantek QT1010 successfully identified.
dvb-usb: Xtensions XD-380 successfully initialized and connected. af9015_init:
af9015_init_endpoint: USB speed:3
af9015_download_ir_table:
usb 1-6.1: New USB device found, idVendor=1ae7, idProduct=0381 usb 1-6.1: New USB device strings: Mfr=1, Product=2, SerialNumber=0 usb 1-6.1: Product: DVB-T 2
usb 1-6.1: Manufacturer: Afatech
af9015_pid_filter_ctrl: onoff:0

If you want me to try any patches etc. please let me know. As far as I see, this device has no IR-interface.

regards

Robert

Quoted 10 lines · Antti Palosaari

Quoted 8 lines · [email protected] wrote:
Hello Antti,
thanks for your work. I tryed your patched files and according to dmesg, it looks like a good initialisation. But after init there are endless failures like:
dvb-usb: error while querying for an remote control event.
af9015: af9015_rw_udev: sending failed: -110 (8/0)
af9015: af9015_rw_udev: receiving failed: -110

Quoted 6 lines

I have no idea what IR-mode is 0x04 but hopefully it will start working now when remote polling is disabled.
Please test again.
regards
Antti

_______________________________________________
linux-dvb mailing list
[email protected]
http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb