phy driver
I've updated the phy driver for smsc devices (smsc.c ). (Which is a question in itself; where do I submit the patch?) It had worked fine with 2.6.22 but 2.6.25 & 2.6.26 seem to have a preference for the generic driver @ phy address 0 over my h/w specific driver for the phy @ phy address 0x1F.
Any suggestions?
Regards,
Joe
Quoted 1 line
Quoted 1 line
Quoted 1 line
Quoted 1 line
Quoted 1 line
"Joseph" == Joseph G Boike <[email protected]> writes:
Hi,
Joseph> I've updated the phy driver for smsc devices (smsc.c ). Joseph> (Which is a question in itself; where do I submit the patch?) Joseph> It had worked fine with 2.6.22 but 2.6.25 & 2.6.26 seem to Joseph> have a preference for the generic driver @ phy address 0 over Joseph> my h/w specific driver for the phy @ phy address 0x1F. Any Joseph> suggestions? Regards, Joe
Wrong list - I guess you meant to send this to netdev at vger.kernel.org instead?
Signature · 1 line
Bye, Peter Korsgaard
Hi Joseph,
That's a question that's better asked in one of the kernel mailing
lists. There might be a list specific to network drivers, but perhaps LKML is a good place to start.
Kind Regards,
Thiago A. Correa
Quoted 14 lines · Joseph G. Boike
I've updated the phy driver for smsc devices (
smsc.c). (Which is a question in itself; where do I submit the patch?) It had worked fine with 2.6.22 but 2.6.25 & 2.6.26 seem to have a preference for the generic driver @ phy address 0 over my h/w specific driver for the phy @ phy address0x1F.
Any suggestions?
Regards,
Joe_______________________________________________
buildroot mailing list
buildroot at uclibc.org
http://busybox.net/mailman/listinfo/buildroot