Skip to contentSkip to conversation

Update mailing list email and archive addresses

PATCH In review Peter Tyser 4 participants 4 messages Sep 10, 2008 – Sep 13, 2008

lore
Share & tools
lore
#0 lore raw

PATCH 1/1 Update mailing list email and archive addresses

---

The reference to u-boot-users at sf.net on this page should also be
updated: http://www.denx.de/wiki/U-Boot/Patches

 MAINTAINERS |    2 +-
 README      |    8 ++++----
 2 files changed, 5 insertions(+), 5 deletions(-)
MAINTAINERS +1 -1
index 64d8409..750e374 100644
@@ -4,7 +4,7 @@
 #									#
 # For any board without permanent maintainer, please contact		#
 #	Wolfgang Denk <[email protected]>					#
-# and Cc: the <[email protected]> mailing lists.	#
+# and Cc: the <[email protected]> mailing list.			#
 #									#
 # Note: lists sorted by Maintainer Name					#
 #########################################################################
README +4 -4
index 44b450c..f6608d2 100644
@@ -60,10 +60,10 @@ Where to get help:
 
 In case you have questions about, problems with or contributions for
 U-Boot you should send a message to the U-Boot mailing list at
-<[email protected]>. There is also an archive of
-previous traffic on the mailing list - please search the archive
-before asking FAQ's. Please see
-http://lists.sourceforge.net/lists/listinfo/u-boot-users/
+<[email protected]>. There is also an archive of previous traffic
+on the mailing list - please search the archive before asking FAQ's.
+Please see http://lists.denx.de/pipermail/u-boot and
+http://dir.gmane.org/gmane.comp.boot-loaders.u-boot
 
 
 Where to get source code:
Signature · 1 line
1.5.4.3
#1 lore raw

[U-Boot] alias in powerpc device tree

It appears that u-boot expects an alias list in the device tree. I only found this in the code for the fdt processing.

I'm working on getting our device tree correct to be able to allow u-boot to alter the device tree.

Is this all that's needed as my device tree is good as far as the kernel booting with it and u-boot passes it fine to the kernel such that it boots?

Or somewhere there's some documentation that I didn't read and should have?

Thanks,
John

This email and any attachments are intended for the sole use of the named recipient(s) and contain(s) confidential information that may be proprietary, privileged or copyrighted under applicable law. If you are not the intended recipient, do not read, copy, or forward this email message or any attachments. Delete this email message and any attachments immediately.

#2 lore raw

[U-Boot] alias in powerpc device tree

Hi John,

Quoted 2 lines · John Linn

It appears that u-boot expects an alias list in the device tree. I only found this in the code for the fdt processing.

Yes. The /aliases node gives tremendous advantages.

Quoted 2 lines

I'm working on getting our device tree correct to be able to allow u-boot to alter the device tree.

Good. The "common/fdt_support.c" file should have all the utilities you need already written, assuming you have a proper /aliases node.

Quoted 6 lines

Is this all that's needed as my device tree is good as far as the kernel booting with it and u-boot passes it fine to the kernel such that it boots?

Or somewhere there's some documentation that I didn't read and should have?

Are you telling us to WTFM? ;-)

Adding the /aliases node and properties should be sufficient. This is not documented in any obvious way in u-boot (sorry). I don't see any documentation in Documentation/powerpc/booting-without-of.txt either. It probably should be added. It probably should be considered to be one of the "Required nodes and properties".

The /aliases node is a standard Open Firmware-ism, but it isn't real obvious to non OF gurus (and I'm not a OF guru).

Quoted 2 lines

Thanks,
John

Best regards,
gvb

#3 lore raw

PATCH 1/1 Update mailing list email and archive addresses

In reply to Peter Tyser

Dear Peter Tyser,

Quoted 9 lines · In message <[email protected]> you wrote:

---

The reference to u-boot-users at sf.net on this page should also be
updated: http://www.denx.de/wiki/U-Boot/Patches

 MAINTAINERS |    2 +-
 README      |    8 ++++----
 2 files changed, 5 insertions(+), 5 deletions(-)

Applied, thanks.

Best regards,

Wolfgang Denk

Signature · 5 lines
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
If a train station is a place where a train stops,
                                           then what's a workstation?