Porting analog support from HVR-1500 to the DViCO FusionHDTV7 Dual Express (Read this one)
A message that is not in the archive (sent off-list or not yet received): [email protected]
I am watching this development with great interest as well. My cable provider seems to send QAM 256 and ATSC signals to me. I can pick up some channels but am missing quite a few.
I have setup a wiki page for the card:
http://linuxtv.org/wiki/index.php/DViCO_FusionHDTV7_Dual_Express
I can't add the regspy output since I run windows in a VM.
I'm happy to test anything but I do not have the skills to help develop code for it.
Thanks for everyones efforts.
Craig
_______________________________________________
linux-dvb mailing list
[email protected]
http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
Quoted 4 lines · Craig Cook
I am watching this development with great interest as well. My cable provider seems to send QAM 256 and ATSC signals to me. I can pick up some channels but am missing quite a few.
I have setup a wiki page for the card:
http://linuxtv.org/wiki/index.php/DViCO_FusionHDTV7_Dual_Express
Just FYI.
The FusionHDTV7 Dual Express is working very well for me, in both ATSC and QAM modes. Analog is not supported.
Check your signal levels if your missing channels, you could be too low or too high.
- Steve
_______________________________________________
linux-dvb mailing list
[email protected]
http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
Quoted 4 lines
The FusionHDTV7 Dual Express is working very well for me, in both ATSC
and QAM modes. Analog is not supported.
Duh! I meant to say analog. I get some channels on a 7+yr old CRT TV that I do not get on my Fusion card.
Craig
_______________________________________________
linux-dvb mailing list
[email protected]
http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb