Skip to contentSkip to conversation

[U-Boot] [ Ramdisk crc error ]

U-Boot sean 2 participants 2 messages Nov 14, 2008

lore
Share & tools
lore

sean

author
#0 lore raw

I've upgrade the capacity of Ram size from 256M to 512M on my custom board based on SEQUOIA.

(U-boot Version:2008.10-rc2)

I built a ramdisk image which is 72MB.( Also, I modified rd_size to 73728)

When I boot up my board, I've got a message like below.

.

.

RAMDISK: Compressed image found at block 0

crc error

EXT2-fs warning: mounting unchecked fs, running e2fsck is recommended

.

.

Why does "crc error" occur??

If I use ramdisk image which is 4MB, "crc error" is not appeared.

And also if I use u-boot for 256MB on 512MB board, "crc error" is not appeared.

Here are my U-boot source which I modified to upgrade memory.

Sequoia.h

#define CFG_MBYTES_SDRAM (512)

Sdram.c

Everything Related DDR Control Register

Init.s

tlbentry( CFG_SDRAM_BASE_2nd, SZ_256M, CFG_SDRAM_BASE_2nd, 0, AC_R|AC_W|AC_X|SA_G|SA_I )

amcc-common.h

#define CFG_SDRAM_BASE_2nd 0x10000000

Thanks.

#1 lore raw
Quoted 7 lines · sean

I've upgrade the capacity of Ram size from 256M to 512M on my custom board based on SEQUOIA.

(U-boot Version:2008.10-rc2)

I built a ramdisk image which is 72MB.( Also, I modified rd_size to 73728)

Quoted 7 lines

When I boot up my board, I've got a message like below.

RAMDISK: Compressed image found at block 0
crc error
EXT2-fs warning: mounting unchecked fs, running e2fsck is recommended

Why does "crc error" occur??

Your RAMdisk image is corrupt, almost undoubtedly in RAM, not the flash storage version.

Quoted 4 lines

If I use ramdisk image which is 4MB, "crc error" is not appeared.

And also if I use u-boot for 256MB on 512MB board, "crc error" is not appeared.

This is indicating your RAM and/or RAM memory map is messed up. I'm guessing that, if you use the memory write command to write to the 256K location (0x10000000), you will find that the same value has "magically" appeared at location 0... IOW, your RAM memory map has two copies of half of your memory (address aliasing).

If you do a RAM test, it should detect this problem.

Quoted 1 line

Here are my U-boot source which I modified to upgrade memory.

Sorry, I'm not familiar with the Sequoia family, so I cannot tell you how to fix this.

Good luck and happy reading,
gvb