Skip to contentSkip to conversation

2GB limit

linux-lvm [email protected] 5 participants 7 messages Jan 20, 2009

lore
Share & tools
lore
#0 lore raw

Hello List,

i have a 32bit Linux box with a 3Ware Raidcontroller and 4x 1TB disks. After installing Debian Etch i had to find out that i am running into some limits.

Is there a way to use a Partition >2GB with 32Linux/LVM?

Cheers,
Mario

#1 lore raw
Quoted 5 lines · On Tuesday, 2009-01-20 at 10:02:34 +0100, [email protected] wrote:

i have a 32bit Linux box with a 3Ware Raidcontroller and 4x 1TB disks. After installing Debian Etch i had to find out that i am running into some limits.

Is there a way to use a Partition >2GB with 32Linux/LVM?

There is no problem creating partitions larger than 2 GB, up to 2 TB :-P

The old-style disk partitioning has no room for larger values. If you don't need the old-style MBR (e.g. for booting), use an EFI label.

Here is an article about the whole stuff:
http://www.cyberciti.biz/tips/fdisk-unable-to-create-partition-greater-2tb.html

HTH,
Lupe Christoph

Signature · 2 lines
| There is no substitute for bad design except worse design.                   |
| /me                                                                          |
#2 lore raw
In reply to [email protected]
Quoted 5 lines · [email protected] wrote:

Hello List,

i have a 32bit Linux box with a 3Ware Raidcontroller and 4x 1TB disks. After installing Debian Etch i had to find out that i am running into some limits.

Is there a way to use a Partition >2GB with 32Linux/LVM?

You hit the 2TB partition max size (I assume you mean 2TB and not 2GB).

With LVM you can use physical disks as a PV, e.g /dev/sdb instead of /dev/sdb1. If you need to boot from the disk too, then you have to use a partition table. With such a small RAID anyway, your easiest option in that case is to create one root disk (and a /boot), say 20-30GB, on a root vg, then two more partitions with the rest of the space and use them as PVs for another vg for data/apps.

You can also put all three partitions into one VG if you prefer that.

Signature · 6 lines
//Morten Torstensen
//Email: [email protected]
//IM: [email protected]

I can't listen to that much Wagner. I start getting the urge to conquer Poland.
	-- Woody Allen
#3 lore raw
In reply to [email protected]
Quoted 5 lines · [email protected] wrote:

Hello List,

i have a 32bit Linux box with a 3Ware Raidcontroller and 4x 1TB disks. After installing Debian Etch i had to find out that i am running into some limits.

Is there a way to use a Partition >2GB with 32Linux/LVM?

You mean 2TiB? Partitions greater than 2GiB (but less than 2TiB) should "just work".

If that's the case, you need to use a real partition table as the traditional MSDOS partitioning scheme is limited to 2TiB partitions or devices (it can't address disk locations beyond this point).

The GPT partition format is widely used on ia64 and does not have this limitation. It's supported by parted and most distribution installers (even for non-Itanium systems).

Regards,
Bryn.

#4 lore raw

We have considerable experience getting parted to work. Basically, the distinction between primary and extended partitions is not needed, nor are partition types. There are other subtle differences too. Very annoyingly, SOME versions of parted interpret megabytes and even kilobytes (but not sectors) as decimal only. For these you have to use unit B (bytes) to regain control. Experiment a little, to see what uses counting from 1 or counting from 0, and what uses last-index or total-size, as these off-by-1 errors can be killer.

Larry Dickson
Cutting Edge Networked Storage

Quoted 32 lines · Bryn M. Reeves
Quoted 8 lines · [email protected] wrote:

Hello List,

i have a 32bit Linux box with a 3Ware Raidcontroller and 4x 1TB disks. After installing Debian Etch i had to find out that i am running into some limits.

Is there a way to use a Partition >2GB with 32Linux/LVM?

You mean 2TiB? Partitions greater than 2GiB (but less than 2TiB) should "just work".

If that's the case, you need to use a real partition table as the traditional MSDOS partitioning scheme is limited to 2TiB partitions or devices (it can't address disk locations beyond this point).

The GPT partition format is widely used on ia64 and does not have this limitation. It's supported by parted and most distribution installers (even for non-Itanium systems).

Regards,
Bryn.

_______________________________________________
linux-lvm mailing list
[email protected]
https://www.redhat.com/mailman/listinfo/linux-lvm
read the LVM HOW-TO at http://tldp.org/HOWTO/LVM-HOWTO/

#5 lore raw
Quoted 3 lines · Larry Dickson

We have considerable experience getting parted to work. Basically, the distinction between primary and extended partitions is not needed, nor are partition types. There are other subtle differences too. Very annoyingly,

Correct.

Quoted 1 line

SOME versions of parted interpret megabytes and even kilobytes (but not

Older versions, right?

Quoted 4 lines

sectors) as decimal only. For these you have to use unit B (bytes) to regain control. Experiment a little, to see what uses counting from 1 or counting from 0, and what uses last-index or total-size, as these off-by-1 errors can be killer.

If you find problems like this with recent versions then please let us know via the parted mailing lists:

http://www.gnu.org/software/parted/lists.shtml

Ironing out the UI inconsistencies in parted is one of the areas that we are keen to improve at the moment so if you hit issues like this, we would very much like to hear about them.

Regards,
Bryn.

#6 lore raw
Quoted 8 lines · Bryn M. Reeves
Quoted 4 lines · Larry Dickson

We have considerable experience getting parted to work. Basically, the distinction between primary and extended partitions is not needed, nor are partition types. There are other subtle differences too. Very annoyingly,

Quoted 6 lines

Correct.

SOME versions of parted interpret megabytes and even kilobytes (but not

Quoted 1 line

Older versions, right?

1.6.19-1.EL had "standard" binary kB and mB.

1.8.1-17.el5 (CentOS 5.2), presumably a newer version, went to the decimal-only kB and mB. There were a lot of other format changes in output, too. We are on top of them, but decimal-only kB and mB is really a bad idea, since it's inconsistent with all previous practice and also with sectors.

Larry Dickson

sectors) as decimal only. For these you have to use unit B (bytes) to

Quoted 21 lines
Quoted 6 lines

regain
control. Experiment a little, to see what uses counting from 1 or counting from 0, and what uses last-index or total-size, as these off-by-1 errors can
be killer.

If you find problems like this with recent versions then please let us know via the parted mailing lists:

http://www.gnu.org/software/parted/lists.shtml

Ironing out the UI inconsistencies in parted is one of the areas that we are keen to improve at the moment so if you hit issues like this, we would very much like to hear about them.

Regards,
Bryn.