eth0: too many iterations (16) in nv_nic_irq.
Subsystems (2)
I have a 2.6.29 kernel which fills up the "dmesg-buffer" with these:
eth0: too many iterations (16) in nv_nic_irq.
$ dmesg | grep -c "too many iterations" 1986
I have seen the commit below.. is the fix just to set the limit to 30 instead? or is there a "real bug" underneath?
commit dccd547e2bf2c01a13c967ae03a705338394fad6
Author: Joe Korty <[email protected]> Date: Wed Oct 29 14:22:16 2008 -0700
forcdeth: increase max_interrupt_work
This eliminates the following often-generated warning from my 64 bit Opteron SMP test stand:
eth0: too many iterations (6) in nv_nic_irq
According to the web, the problem is that the forcedeth driver has a too-low value for max_interrupt_work. Grepping the kernel I see that forcedeth has the second lowest value of all ethernet drivers (ie, 6). Most are in the 20-40 range. So this patch increases this a bit,
from 6
to 15 (at 15 forcedeth becomes the driver with third-lowest max_interrupt_work value).
My test stand, which used to print out the above warnings repetitively whenever it was under heavy net load, no longer does so.
Quoted 9 lines · Jesper Krogh
I have a 2.6.29 kernel which fills up the "dmesg-buffer" with these:
eth0: too many iterations (16) in
nv_nic_irq.$ dmesg | grep -c "too many iterations" 1986I have seen the commit below.. is the fix just to set the limit to 30 instead? or is there a "real bug" underneath?
Probably. Still it is worth trying the '30' as an experiment.
The underlying cause is likely to be something on your system holding off the eth0 interrupt for short periods of time. An SMI is one such possibility.
I can't help but wonder if the printk itself is causing enough of a delay to make this condition reoccur indefinately, under sufficiently heavy net load, once it occurs once. It might be better to instead use printk_ratelimit.
Joe
Quoted 26 lines
commit
dccd547e2bf2c01a13c967ae03a705338394fad6Author: Joe Korty <[email protected]> Date: Wed Oct 29 14:22:16 2008 -0700forcdeth: increase
max_interrupt_workThis eliminates the following often-generated warning from my 64 bit Opteron SMP test stand:
eth0: too many iterations (6) in
nv_nic_irqAccording to the web, the problem is that the forcedeth driver has a too-low value for
max_interrupt_work. Grepping the kernel I see that forcedeth has the second lowest value of all ethernet drivers (ie, 6). Most are in the 20-40 range. So this patch increases this a bit, from 6 to 15 (at 15 forcedeth becomes the driver with third-lowestmax_interrupt_workvalue).My test stand, which used to print out the above warnings repetitively whenever it was under heavy net load, no longer does so.
Signed-off-by Joe Korty <[email protected]>Cc Ayaz Abdulla <[email protected]>Cc Jeff Garzik <[email protected]>Signed-off-by Andrew Morton <[email protected]>Signed-off-by Jeff Garzik <[email protected]>