NAND on mpc8360erdk
I am in the middle of NAND debugging on a MPC8544 based system.
In the following code for the mpc8360erdk, why is there the instruction "out_8(upm->io_addr, 0x0);" in the for loop. Is that board specific?
static void upm_setup(struct fsl_upm *upm)
{
int i;
/* write upm array */
out_be32(upm->mxmr, MxMR_OP_WARR);
for (i = 0; i < 64; i++) {
out_be32(upm->mdr, upm_array[i]);
out_8(upm->io_addr, 0x0);
}
/* normal operation */
out_be32(upm->mxmr, MxMR_OP_NORM);
while (in_be32(upm->mxmr) != MxMR_OP_NORM)
eieio();
}Hi,
Quoted 4 lines · Renaud barbier
I am in the middle of NAND debugging on a MPC8544 based system.
In the following code for the mpc8360erdk, why is there the instruction "
out_8(upm->io_addr, 0x0);" in the for loop.
it is a dummy write transaction step of the UPM RAM array programming algorithm to hit the relevant chip select. Take a look at section '10.4.4.2 Programming the UPMs' of the MPC8360E Reference Manual, the steps to write the UPM RAM array are described there.
Quoted 1 line
Is that board specific?
No.
Anatolij
Quoted 1 line · Renaud barbier
I am in the middle of NAND debugging on a MPC8544 based system.
BTW: also the TQM8548 module uses FSL UPM NAND.
Wolfgang.
Thanks. I supposed the NAND on the TQM8548 is connected to the CPU as per Freescale Application Note.
Quoted 9 lines · Wolfgang Grandegger
Quoted 2 lines · Renaud barbier
I am in the middle of NAND debugging on a MPC8544 based system.
BTW: also the TQM8548 module uses FSL UPM NAND.
Wolfgang.