libata: Add multi-count transfer debugging
PATCH 1/1 libata: Add multi-count transfer debugging
On my Asus M2A-VM (SB600) board, the SATA disks use multi-count transfers only with some BIOS variants.
Dumping the relevant config words helps debugging a lot.
drivers/ata/libata-core.c +4 -4
@@ -2390,11 +2390,11 @@/* print device capabilities */ if (ata_msg_probe (ap))ata_dev_printk (dev,KERN_DEBUG , -"%s: cfg 49:%04x 82:%04x 83:%04x 84:%04x " -"85:%04x 86:%04x 87:%04x 88:%04x\n" , +"%s: cfg 47:%04x 49:%04x 59:%04x 82:%04x 83:%04x" +" 84:%04x 85:%04x 86:%04x 87:%04x 88:%04x\n" , __func__, - id[49 ], id[82 ], id[83 ], id[84 ], - id[85 ], id[86 ], id[87 ], id[88 ]); + id[47 ], id[49 ], id[59 ], id[82 ], id[83 ], + id[84 ], id[85 ], id[86 ], id[87 ], id[88 ]);/* initialize to-be-configured parameters */ dev->flags &= ~ATA_DFLAG_CFG_MASK ;
Quoted 27 lines · Carl-Daniel Hailfinger
On my Asus M2A-VM (SB600) board, the SATA disks use multi-count transfers only with some BIOS variants.
Dumping the relevant config words helps debugging a lot.Signed-off-by Carl-Daniel Hailfinger <[email protected]>drivers/ata/libata-core.c +4
-5@@ -2390,11 +2390,11 @@/* print device capabilities */ if (ata_msg_probe (ap))ata_dev_printk (dev,KERN_DEBUG , -"%s: cfg 49:%04x 82:%04x 83:%04x 84:%04x " -"85:%04x 86:%04x 87:%04x 88:%04x\n" , +"%s: cfg 47:%04x 49:%04x 59:%04x 82:%04x 83:%04x" +" 84:%04x 85:%04x 86:%04x 87:%04x 88:%04x\n" , __func__, - id[49 ], id[82 ], id[83 ], id[84 ], - id[85 ], id[86 ], id[87 ], id[88 ]); + id[47 ], id[49 ], id[59 ], id[82 ], id[83 ], + id[84 ], id[85 ], id[86 ], id[87 ], id[88 ]);/* initialize to-be-configured parameters */ dev->flags &= ~ATA_DFLAG_CFG_MASK ; --
Quoted 4 lines
To unsubscribe from this list: send the line "unsubscribe linux-ide" in the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Keep in mind that multi-count transfers are only meaningful for PIO read/write commands (it controls the number of sectors transferred for each DRQ assertion), which would only be used if the device didn't support DMA - unlikely for SATA..